answersLogoWhite

0

You need a special tool to get the window crank off then take out all of the screws you can find {In each corner etc}. Then you need a "J" shaped tool with a "V" in the end to pull out the nylon retainers that are all around the outside of the trim pannel. They hang in there pretty good so you need a good puller to get them out. Both tools are available at good parts stores and you may want to rent them but they aren't very expensive.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do I repair an Olds intrigue fuel door?

i cant open my fuel door


How do you remove the rear inside door panels on a 2000 Olds Alero?

pop the switch panel off and then the door mount support with a socket


How do you install a heated side mirror on a 2000 Olds Intrigue?

installing the mirror is simple enough. 3 nuts hold it on. the problem is that the electrical lead goes too far down into the door panel to get at it without removal of the door panel. that's the real problem and I can't find info on that without buying the chassis manual at $100.


What size are the door speakers in the 98 olds intrigue?

5 1/4"


How do you take door panel off a 2000 oldsmobile intrigue?

To remove the door panel from a 2000 Oldsmobile Intrigue, start by disconnecting the negative battery terminal for safety. Then, use a flathead screwdriver to gently pry off the plastic cover from the door handle to access the screws. Remove any screws securing the panel, typically located near the handle and along the edges. Finally, carefully pull the panel away from the door, releasing any clips, and disconnect any wiring harnesses for power windows or locks before fully removing it.


How do you repair power window on 98 olds intrigue?

To repair the power window on the 1998 Old Intrigue, you will first need to remove the interior door panel to access the window motor, switch, and actuator. You can then determine which part is broken or damaged and replace that part.


Where is fuel filter on 99 olds intrigue?

Driver's side along the edge under the back door.


How do you remove and replace Window motor regulator on a 2000 intrigue?

remove your door panel there will be three screws holding it on. then you have to remove the screws holding your window to the regulator. then unbolt regulator and motor from door. Undo wiring going to motor.


How can you open the driver door panel of 2000 cadillac Seville?

Opening the driver door of a 2000 Cadillac Seville is easy. All you have do is pop off the door panel.


How do you remove the door panel on a 2000 Plymouth Voyager?

Go to this website. It will show how to remove the door panel.


How do you remove the front door panels on a 98 olds intrigue?

The screws are around the door handle and the door latch pop out the plastic behind the latch their may be a screw underneath the door panel and lift the window switch cover out from the bottom next to the handle striaght up off the metal clip slide it through the door then just pop it off the retainers


On a 99 intrigue how do you remove the rear door panel?

You would need to remove all of the trim pieces from it, and then pry it off of the door with a door panel removal tool. An instructional video has also been included below, to help walk you through the correct steps on removing the door panel.