On my 2005 there is a button located on the underside of the steering column. i believe you push and hold it until the light goes out. This tells the computer that all tire pressures are acceptable and sets the minimum at which any one tire can be. before you do that, check all your tire pressures including your spare. Your light may be telling youthat one of your tires is low. Check your manual to determine the exact proper procedure.
I dont know how to turn that sensor off; although, i do have a 2006 tundra and if your spare tire is low that light will come on as well so you might want to check that out.
How do you cancle or turn off the 2006 Toyota tundra's tire warning pressure system.? other than putting tape over the light.
Perhaps you should try checking your tire pressure and reinflating them to the recommended pressure.
Disable it or turn it off. The reset is most likely by your right knee just under the dash. That's where it's at on the new Tundras. BUT. if it keep coming on and you checked the tires, then check the spare. If it's 5 Lbs out of range with the other tires, than that's your problem. They ALL must be at the same pressure.
How do you turn off the check engine light off and the tire pressure light off the air bag light off
First of all check the spare tire pressure.
I have a 2006 Chevrolet C4500 Duramax Diesel and I would like to know how to turn off or reset the check engine light on the truck.
There is no way a user can reset the tire pressure light manually except to make sure there is tire pressure above 25-26 lbs on all 5 tires. The tire pressure system also monitors the tire pressure in the spare tire. So after you have checked that all the tires on the car (pressure should be about 32 lbs check your driver side door sticker for specifics) make sure to check the air pressure in the spare and fill as needed. This should solve your problem and turn that annoying little light off.
I'll make a suggestion. Next time type your questions in English.
Check the Freon pressure first. The AC compressor will not turn on if the Freon pressure is too low.
Try disconnecting the battery.
check for pump to activate at key turn on.