0
What else can I help you with?
How do you turn off chime on howard miller mason clock?
You cannot turn off the chimes on this clock
How do you turn alarm off on atomic clock?
shutting off alarm on barolo atomic clock
How do you turn off the clock in a 1987 Celebrity?
If you cut off the hot power that goes to the radio all of the time, that will turn the clock off BUT you will not have any display or presets.
What would cause the clock to reset every time you turn on and off the car?
the Clock is probably wired to the ignition and power is turned off every time you turn off the Car there fore you have to reset the clock.
How do you turn off alarms on barolo atomic clock?
shutting off alarm on barolo atomic clock
How do you stop the alarm clock from waking you up?
Turn off the alarm clock.
Does the IPhone alarm clock turn itself off?
no,it will keep ringing till u turn it off
How do you turn off the clock in a 2001 Toyota Tacoma?
Pull the fuse.
How do you turn off the grandfather clock chimes?
To turn off the chimes on a grandfather clock, you typically need to stop the clock from chiming at the specific times by adjusting the chime selector lever. This lever is usually located inside the clock case near the movement mechanism. Move the lever to the silent position to mute the chimes. Consulting the clock's manual or contacting a professional for assistance may be necessary if you are unsure about how to turn off the chimes.
How do you get the digital clock in a 2001 Mercury Cougar zn to go off?
The dash clock in a New Edge Cougar does not turn off, unless you disconnect the battery.
How do you set the clock in a 2002 Chevy Siverado?
turn radio off n use radio knobs to set the clock
How do you change the time on a Nissan Pulsar?
You need to turn off the radio and then turn it back on while holding down the clock button from there use the up and down buttons to change hour then press clock again and use the up and down buttons to change the minutes then turn off the radio. When you turn the radio on again the clock should be working
