To remove the rear seat in a Saturn SL2, start by locating the bolts securing the seat bottom. Typically, you'll need to unscrew these bolts using a socket wrench. Once the bolts are removed, lift the seat bottom up and out of the vehicle. For the seat back, look for any additional bolts or clips securing it, remove them, and then gently pull the seat back out.
2000 sonata rear seat removal
I have a 1993 318i 4-door. Rear seat removal is extremely easy. The seat is held in place by 2 clamps in the seat which fit over corresponding fittings on the chassis. These clamps are positioned beneath the two main seating positions. To remove the seat, simply pull up on the front of the rear seat at each seating position which will easily disengage the clamps. Lift the front up about 30 cm. Pull the whole seat bottom forward which will disengage the rear of the seat from the seat back. Remove from car. Installation is reverse of removal.
In the back seat, under the front leading edge of the seat will be some 13mm bolts. this should make ease of the back seat removal.
salvage yard
1. Using the ignition unlock the tool box. 2. Pull back the tool box and take it from the assist bar area. 3. Remove the nuts securing the rear seat . 4. Pull up on the rear of the seat and unhook it from the retainer on the front seat. 5. Remove the nuts securing the front seal from the rear fender. 6. Pull the rear seat toward the rear and remove it. 7. Install by reversing these removal steps.
There are two tabs on the right and left side in-between the cracks of the seat. Pull up on those and the seat will come out.
Removal of the rear or 3rd row seat from any year Villager is a matter of taking out six bolts. There are four bolts at the rear of the seat (two on each side) located at the bottom corners. On the front bottom corners, the bolts are hidden by plastic trim plugs which must be carefully removed to gain access to the bolt heads. Once these are removed, lift straight up on the seat and have an assistant help with the final removal of the seat. IT IS HEAVY !!!!
Are you asking how to??
yes
The minimum rotor thickness for a 1992 Saturn SL2 is .625 inches for the front and .350 inches for the rear if equipped with rear disc brakes.
To remove the rear seat in a 1989 Cadillac Eldorado, first, locate and remove any bolts or screws securing the seat bottom to the floor. Once unfastened, lift the front of the seat bottom and pull it forward to disengage it from the hooks at the back. After removing the bottom, you can access the rear seat back, which may require unbolting or unclipping from the vehicle's frame. Carefully detach it to complete the removal process.
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.