Im writing this by memory so my directions might be a little shaky but:
you will need:
electric tape, sharp knife, guitar or microphone chord, empty hair pomade can or any round plastic container, hot glue, old speaker (preferably smaller)
1.use the knife to cut a hole in the top of the pomade can (or not if you have a container that already has a hole in it) all the way around the outside rim big enough for the speaker to sit in.
2.take apart the speaker and isolate just the speaker itself.
3.cut the guitar/microphone chord at the end to expose the wires inside.
4.cut another small hole big enough for the chord to fit through in the side of the container.
5.fit the speaker inside the container.
6.use electric tape (or soldering iron if available) to attach the wires from the chord to the back of the speaker.
7.hot glue or tape the lid to the container back onto the body.
8.with speaker now encased in container hook up the chord to an amp or some type of audio device.
9.voila! microphone!
Kool-aid
You can make fake chicken with tofu and spices.
If you have an inkjet printer, there is special temporary tattoo paper.
You don't. Go to the store and get one of the sprays or creams.
Yes, I can make homemade chili.
pva glue is not waterproof, however, some recommend mixing with nail hardener to make a homemade nail glue
how to make a homemade confettie shooter blower
1.)Mix water and flour then shake 2.)You can put white fabric softener in the bottle 3.)Mix sunscreen and water
People can make use of harmonica microphone when singing by holding the microphone if it is a hand held harmonica microphone or using a stand to bring the harmonica microphone to your height making it easy to use whilst singing.
yes,mold is a homemade bacteria
homemade dough is dough u make by hand
To properly plug a microphone into an amp, first make sure the microphone is turned off. Then, connect the microphone cable to the input jack on the amp labeled "MIC" or "Microphone." Make sure the connection is secure. Adjust the volume levels on both the microphone and the amp as needed. Turn on the microphone and the amp, and test the sound to ensure it is working properly.