To remove a dent in the leather seat of a car, soak a towel in hot water then wring most of the water out. Fold the towel into quarters and set it down over the dent. Place a heavy object on top and leave for 2 hours. After 2 hours repeat this process another 3 times. Rub a leather conditioner into the seat and leave untouched for 24 hours. After this time, the dent should be gone.
To remove the seat leather on a BMW Z3, start by disconnecting the battery to ensure safety. Then, remove the seat from the vehicle by unscrewing the bolts that secure it to the floor. Once the seat is out, carefully detach the leather covering by unfastening clips or screws that hold it in place, starting from the back and working your way to the front. Be cautious not to damage the foam or frame underneath as you remove the leather.
Remove seat from car. Remove leather seat covering cushion. Seat heating element is located under leather. If unfamiliar, leave to a professional.
By purchasing a car with cloth seats.
try to vacuum out the water remaining. carefully Remove the leather by either unzipping or carefully cutting the leather. replace or steam clean the inside padding then replace the leather.
To get rid of mildew, mix together water and rubbing alcohol and then use mixture to scrub the seat. Then use a towel to dry the seat.
Typically "leather seat trim" means that small amounts of leather are used decoratively as accents. "Leather Seats" typically means that the seats are upholstered almost entirely (more than 90%) with leather.
get some 409 and a rag it will come of soon enough
The new car smell is caused by products used on the leather to clean and preserve it. It is a part of the leather or vinyl. The best way to remove it is to open the windows and allow it to air out. It will fade with time.
For the bottom cushion, there is a single bolt located above the transmission hump. Remove it and pull up seat cushion. To remove seat back, three bolts must be removed. One is located behind the center flap of material where the armrest would be stored. Move the fabric, remove bolt. The other two bolts to the seat back are located on either bottom corner. They're hidden under leather patches of material (to avoid leather wear from the bolt head). Remove these and the seat back will come off with ease. All three are 10mm bolts if memory serves me....
The best way to remove oil stains from leather is to use a smoothing iron and blotting paper.
There is a company that makes leather seat covers and the company is called http://www.barbari.com/.
Just under the front of the bottom on each side of the seat are two small black levers that you have to push down. These will unlatch the bottom seat. They may also be covered by the leather, so you might have to push the leather back a little to get to them. Once the bottom seat is out, you can take the back cushion out. Do this by removing the bolts where the seat belts attach to the floor using a 12 mm scoket. They may be covered by a leather flap. Then you can push it up and out.