Cash
Sewing machines use two spools of thread, unlike hand sewing, which uses one fixed-length piece. You can emulate the machine-stitching process by hand. Imagine you have a needle through which the thread from a large spool is threaded and a second, smaller spool of thread. Push the needle eye-end first through the fabric from above. Pull the loop of thread on the back side bigger, until you can pass the little spool through the loop. Now, from above pull the top thread tight to close the loop back up again. That is all a sewing machine does. The arm at the front that moves up and down a lot supplies the slack to make the bottom loop big enough, and then moves back up to take up all the slack, and to pull a tiny bit more thread off of the top spool through the tensioning mechanism. The hard-to-visualise bit is at the bottom, where the bottom spool is passed through the loop. The key to understanding it is that the spool and whatever carrier it is in "floats" in a space rather than actually being fastened to the rest of the mechanism. There is a gap round it on all sides (though sometimes an oddly shaped one) which allows the loop of top-thread to pass all the way round it. Typically a hook of some sort grabs the top-loop near the needle eye, and pulls the loop bigger while passing that loop round the outside of the bottom spool assembly. If you operate the machine by hand with the covers off you should be able to see this happening.
Spool pins are used on sewing machines to hold the spool of thread. Most or vertical, some that are horizontal use a spool cap to secure the spool of thread. Some machine come with spool nets to cover the spool to ensure the thread enter the machine evenly. Some machines come with an extra spool pin that fits into a small hole on the top of the machine to hold a second spool of thread.
A website that can customize cabinet drawers is at the following address: http://www.quikdrawers.com/. They make all types of drawers, from bathroom drawers to kitchen drawers.
A spool of thread is very cheap. Spools of thread can be as cheap as a dollar or less a spool.
chest of drawers or set of drawers
That spool is just the right size for my project.
A real reel is a genuine spool.
Emma Spool was created in 1982.
To wind a Ryobi weed wacker spool, first remove the spool from the trimmer. Then, wind the trimmer line around the spool in the direction indicated on the spool. Make sure to evenly distribute the line and avoid overlapping. Finally, reattach the spool to the trimmer and you're ready to use it.
If you are talking about a diff. A mini spool replaces the planetary gears in the diff centre. A full spool replaces the whole centre except the crown wheel.
The collective noun for drawers is a chest of drawers .The collective noun for a different type of drawers is a pair of drawers (a word some people use to mean underpants).
To change the spool on an RTE 115 trimmer, first, ensure the trimmer is turned off and unplugged for safety. Remove the old spool by pressing the release tabs on the spool cover and lifting it off. Then, insert a new spool by aligning it with the spool holder and ensuring the line feeds through the eyelets. Finally, replace the spool cover securely, and the trimmer is ready for use.