There's a button under the the key on the ignition terminal. Push it and pull out the key!
To remove the key from the ignition of a 1990 Nissan 300ZX, ensure the vehicle is in the "Park" position. Turn the key to the "Off" position and press it in slightly while attempting to turn it to the "Lock" position. If the key doesn't release, check if the steering wheel is locked, as this can sometimes prevent key removal. If the issue persists, there may be a problem with the ignition cylinder that may require professional assistance.
In a 1990 Nissan 300ZX, the cylinder switch, also known as the ignition switch, is located on the steering column. To access it, you typically need to remove the plastic cover around the steering column. The switch is mounted near the ignition lock cylinder, which is where the key is inserted to start the vehicle.
If your 300zx has no power to the entire car and the key is stuck in the ignition you have to press the emergency button located in the ignition. Simply remove the black piece from your ignition.(its a black cap)..and when removed you will see a small red button..if you see that push that and press the "push" black button, turn your key and pop it out.
Removing a ignition lock cylinder from a 2002 ford windstar with no key
some low life scum tried to steal my 300zx, and totally f..cuk,d my ignition (key entry) and cant seem to work out the tool i need to remove the old one.. ?????
i suggest u either get a new key or ignition
the ignition keys are dealer only items.
just worn out... have to push center of lock in while removing key
try wiggling the steering wheel it has a lock on it
Maybe put the key in?
The key to my ignition broke off in the ignition. Luckily, I was able to insert the remainder of the key in the ignition and turn on my car. In order to fix the problem, I had to take my car to the dealer and I am pretty sure they removed it and installed a new ignition "key hole" keyed to my car. It is a 1990, and I believe the problem happened approx 1993?
To read diagnostic codes on a 1990 Nissan 300ZX, first, locate the diagnostic connector under the driver's side dashboard. Use a jumper wire to connect terminals E1 and TE1 in the connector. Then, turn the ignition key to the "on" position without starting the engine; the check engine light will blink the diagnostic codes. Count the blinks to interpret the codes according to the Nissan service manual for troubleshooting.