answersLogoWhite

0

A needle.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How can you fix cross thread damage?

On a bolt, you can sometimes clean out the thread with a knife or hacksaw blade enough to start the nut and tighten it to reform the thread past the damage. In a hole, they make thread chasers that will recut the the thread. You can just run a tap in the hole and it will usually find the old grooves.


Hole to thread shoe laces through?

Eyelet


What is the relationship between a nut thread and a screw thread?

when a spiral groove is cut over a hole, then it is nut thread. when a spiral groove is cut over a shaft, then it is screw thread.


What is the difference between internal flush and full hole thread?

The difference between internal flush and full hole thread is that the roots of the full-hole tool joints are rounded, and the roots for the internal-flush joints are flat.


What is tapped hole?

That is hole that has been drilled, then had a thread 'tapped' into it so you can insert a machine screw or bolt.


How can I fix a hole in the crotch of my jeans?

You can fix a hole in the crotch of your jeans by sewing it up using a needle and thread or by using a patch to cover the hole.


What is the hole on top of a needle called?

The hole on top of a needle is called the eye. It is where the thread passes through when sewing.


What is the hole called in a sewing needle?

The hole in a needle is called an eye. The eye of the needle is where you pull the thread through.a hole


How do you install thread inserts?

To install thread inserts, first drill a hole in the material. Then, use a special tool to screw the insert into the hole until it is flush with the surface. This creates a strong threaded connection for screws or bolts.


How can I sew a patch over a hole by hand?

To sew a patch over a hole by hand, first cut a patch slightly larger than the hole. Place the patch over the hole and pin it in place. Thread a needle with matching thread and knot the end. Start sewing around the edge of the patch, using small, even stitches. Continue sewing until the patch is securely attached. Knot the thread on the backside to finish.


What is a slightly tapered thread that is characteristic of a tap.?

It has got to be tapered to get in a fresh hole. Then you can finish it up with a square one to tap out the bottom of the hole.


What is a slightly tapered thread that is characteristic of a tap?

It has got to be tapered to get in a fresh hole. Then you can finish it up with a square one to tap out the bottom of the hole.