1 1/2 or 2 inch galvanised.
You cut it to size and air nail it in the tongue of each piece.
To create a tongue and groove joint using a hand router, first, set up the router with the appropriate bit for the desired joint size. Then, carefully guide the router along the edge of one piece to create the groove. Next, adjust the router to create the matching tongue on the edge of the other piece. Ensure both pieces fit together snugly for a strong joint.
The variables include the support mechanism under the floor (ie: spacing & size of floor joists, structural strength of the tonque and groove flooring material, (ie: is it pine, birch, maple, etc.) and how thick will the flooring be?
The recommended size of nails for use with a nail gun is typically 10d nails.
The recommended size and type of nails for framing a structure are typically 16d common nails. These nails are strong and long enough to securely hold the framing components together.
No, the size of your tongue is determined by genetics and cannot be permanently altered. Stretching exercises or tongue piercings may temporarily change the appearance of the tongue, but they will return to their original size.
1.5 or 2 inch finish nails
A pack of nails typically includes various quantities of nails, ranging from a few dozen to a few hundred, depending on the size and type of nails.
14g
3/8 inch, standard groove you will usually find on small rimfire .22 rifles
A cow's tongue is about the size of a ruler (12 inches or 30 cm) or a foot long.12 inches or 30 centimetres roughly the size of a ruler.
Depends on the size of the house.