0
What else can I help you with?
What does the stop motion screw do on the sewing macchine?
What does the stop motion screw do on the sewing machine
Why a Screw-diver have magnetised tip?
To hold the screw in place to stop it dropping
How do you stop your ear piercings from healing up?
I'd say keep wearing your earrings, but it depends on how long you have had them in if you have onky had them in like me, then you should leave your starter ones in for about 4 months so then when you take them out the hole will not close as much as it would if it was only 6 weeks, if they try to close up without having any earrings in for a while, i suggest you put bio oil around the back of your ear and the front, then try to get the earrings back in and give it a little wiggle until you can feel the stud at the back of your ear, hope this helped :)
When did they stop making the original Xbox?
They should bring back Xbox Like they came back with P's 3
Why is your peugeot epert 2.0 hdi a problem to start when the engine is warm?
There is a large screw which goes through the coil pack into the engine block. That screw will get to hot and then cause the engine to stop or not start back when it's hot.
How do you set throttle stop screw on198 ranger 2.3 5 spd?
To set the throttle stop screw on a 198 Ranger with a 2.3L engine and a 5-speed transmission, first locate the throttle stop screw on the throttle body. Start the engine and allow it to reach normal operating temperature. Adjust the screw to set the idle speed, typically around 750 RPM for this model, ensuring the throttle plate is fully closed when at rest. Finally, double-check the adjustment by re-measuring the idle speed and making any necessary fine-tuning.
Did jeep stop making 2 door wranglers?
Yes but only for 2 years it will be back 2014
Singer 201-2 balance wheel not tighten I loosen the stop motion screw to wind the bobbin and now I am unable to tighten the same to allow for the blance wheel to engage. Please help?
There's a small screw inside the stop motion screw on the balance wheel of the machine. Make sure you're not loosening that screw. The part to loosen is the silver "wheel" within the balance wheel, not the screw that holds the silver wheel in place. Be sure to check the small screw that holds the silver wheel in place and make sure it is tight. If the screws and wheels check out ok, you may have a stripped the threads on the stop motion screw causing it to continue to turn and not tighten.
Is there any easy way to close a hole in the earlobe after 20 years?
Just stop wearing earrings, and eventually it will close up. It may take a few months, and a small indentation will remain, but it will close back up.
When will they stop making pontiac's?
Did u stop making ponic
If you get your ears pierced and stop wearing them later will people be able to tell you had your ears pierced?
I have recently stopped wearing earrings regularly and when people squint they can only just see the holes, but my earrings fit anyway.
Why did Homestarrunnercom stop making new episodes?
I dont think they stopped....check back on it. it was updated in december 2010.
