The stapler requires a 15/32" crown staple. There are original Bates staples available on Ebay but they want an ungodly amount of money for them. I'm currently trying to find a decent priced compatible staple for my Bates H-30
Swingline staples (ACCO) would fit Bates 224XHD available at Coveys (Fredericton)
-log [h30+]
The Bates 213HD stapler uses standard size staples, specifically 1/4 inch (6mm) staples. These staples are typically referred to as 24/6 staples, which are commonly used in many office staplers. Always ensure to check the manufacturer's guidelines for optimal performance.
Depends if you have a Hydroxide [OH^-] or a Hydronium [H3O^+] solution.The Ph of an acid or base is determined by the concentration of the Hydronium [H30^+]. So just find out [H30^+], then use the equation "-log10[H30^+]. Should be between 1-14.7= neutral. lower than 7 = acid. higher than 7= base.If you have a hydroxide to begin with. Ie. NaOH. Then you will have the concentration for the OH, which is = to NaOH. If you get something like Ca(OH)2 then you just multiply your concentration of Ca(OH)2 by 2 to get (concentration)[OH^-].Then use the equation 10^14M/ [OH^-] to find out [H30^+].Once you have the [H30^+] just use the -log10[H30^+]
They load from the back. Push in and up and the back comes off.
You don't. Just throw the thing away and get a swingline
Grasp the upper portion with the "Bates" label and try to pull it away from the portion that says "9000." If you can't get them apart, it's probably because a staple has jammed. Try keeping the stapler level (horizontal) and vigorously trying to staple and eject any jammed staples. You may need needle-nose pliers to pull out any visible portion of a jammed staple. To get better access to the opening where staples have jammed, pull down on the base, freeing it from the upper "Bates" portion, which is jammed to the "9000" portion. Another trick that may work to get the "Bates" and "9000" apart is to use a screwdriver or other tool to push forward on the small circular metal catches which are located on the sides near the front of the "9000" portion. With a lot of tugging, you'll get "Bates" and "9000" apart, and then you'll see a tray into which staples are loaded. Makes sure the loaded staples slide freely forward and back and then push them to the front. Push "Bates" and "9000" back together, and you're ready to go until the next jam, which will be soon.
No, it is not.
There are many places where one could find a copy of the Staples Center seating chart. The best place to find the Staples Center seating chart would be places like Staples.
To load staples into a Bates 224XHD Power Arm Stapler, first, ensure the stapler is unplugged for safety. Open the stapler's magazine by pressing the release button or lever, then slide out the magazine tray. Insert a new strip of staples into the tray, ensuring they are aligned properly, and then slide the tray back into the stapler until it clicks securely in place. Finally, close the stapler and it's ready for use.
you go to staples
this penny policy was takem out by kate bates for charles bates can you please tell me how to claim from this policy