Very easy actually... You have a tray up on top of the dash where the hazard switch is. open the tray, and pull on it. It is held by clips and will come out very easily. Dont pull it all the way out, because the hazard switch is connected behind the tray. Disconnect that. Then you have the lower part of the console.. hold both sides of that piece and pull out, its also held on by clips. You then have a total of 6 screws(philips) unscrew them all and pull the radio out.
whats the wiring color codes for my 98 sentra radio
removal
I do not know, but I am having the same problems with the removal of my 1994 tracer's stereo
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00
To remove the VW Sharan car stereo, first, ensure the vehicle is turned off and disconnect the battery for safety. Use a stereo removal tool or flathead screwdriver to gently pry off the trim surrounding the stereo. Once the trim is removed, unscrew any mounting screws securing the stereo, and carefully pull it out from the dashboard. Finally, disconnect the wiring harness and antenna from the back of the stereo to complete the removal.
To remove the car stereo from a 2003 Vauxhall Combo van, first, disconnect the battery to ensure safety. Use a flat-head screwdriver or a panel removal tool to gently pry off the trim surrounding the stereo. Once the trim is removed, unscrew the stereo’s mounting screws and carefully pull the unit out. Disconnect the wiring harness and antenna cable from the back of the stereo to complete the removal.
Follow the link below. Its a step by step on how to do this.
Nissan Sentra
You Need special Tool To remove It .....You Can Usally Find The Tool in Parts stores Like Auto Zone Or Your Local Auto Stereo Installation Shop....
In Car Stereo was created in 1983.
To remove a Porsche car stereo, first, ensure the vehicle is off and disconnect the battery to avoid any electrical issues. Use a trim removal tool to carefully pry off the surrounding trim or bezel, exposing the stereo unit. Unscrew any mounting screws securing the stereo in place, then gently pull the stereo out and disconnect the wiring harnesses at the back. Finally, reverse the process for installation of a new stereo.
here is a link that i found that shows you step by step GUIDE http://www.sound-repair.com/index.php/acura-mdx-01-03-car-stereo-removal/ http://www.sound-repair.com/index.php/acura-mdx-01-03-car-stereo-removal/ i hope this helps you out ........by c0vert