What's the Prob? The drivers door "See's" about 1000% more work load than other doors. Opening and closing (slamming) has a habit of destroying component's. Unless you know the "In's and outs" of circuit testing, all you can do is test the disconnected switch. If switch good, PW moter bad. There is not a lot to eliminate to diagnose the problem. If none of your windows work, and they did before, I would look up stream to the fuse box, and farther if necessary.
To reset the power windows on a 2000 Toyota 4Runner, start by ensuring the ignition is in the "ON" position. Fully lower the window using the switch, then hold the switch in the down position for a few seconds after it reaches the bottom. Next, raise the window fully while holding the switch up for a few seconds after it reaches the top. This process helps recalibrate the window's automatic function.
The 2011 Toyota 4Runner is 6 ft. 3.8 in. (75.8 in.)120V AC Power Point wide.
The 2005 Toyota 4Runner is 6 ft. 1.8 in. (73.8 in.)1 one-touch power windows wide.
The 2004 Toyota 4Runner is 6 ft. 1.8 in. (73.8 in.)1 one-touch power windows wide.
The 2006 Toyota 4Runner is 6 ft. 3.2 in. (75.2 in.)1 one-touch power windows wide.
The 2009 Toyota 4Runner is 6 ft. 3.2 in. (75.2 in.)1 one-touch power windows wide.
The 2003 Toyota 4Runner is 6 ft. 1.8 in. (73.8 in.)1 one-touch power windows wide.
The 2008 Toyota 4Runner is 6 ft. 3.2 in. (75.2 in.)1 one-touch power windows wide.
The 2007 Toyota 4Runner is 6 ft. 3.2 in. (75.2 in.)1 one-touch power windows wide.
Is there a separate fuse for every electric window in the 1999 landcruiser and if there is where are they.
They are located below the power windows, in the door.
The 2002 Toyota 4Runner is 5 ft. 6.5 in. (66.5 in.)12V front and 12V rear power outlet(s) wide.