They had an issue with low oil pressure holding the clutch's in. This allowed the clutch's to slip a very small amount over time requiring the transmission to be rebuilt. If the pressure is increased when it is rebuilt it cures the problem.
Yes, there is a transmission in a 1990 Mazda RX7 convertible.
5.7 quarts for automatic transmission
There is no reservoir. All the transmission lube in stored inside the transmission.
can you answer the question i have a 1990 ford ranger with a Mazda manual transmission what fluid does it require
To remove the transmission from a 1990 Mazda B2200, start by disconnecting the battery and draining the transmission fluid. Then, remove the driveshaft by unbolting it from the rear axle and the transmission. Next, detach the transmission mounts, shift linkage, and any electrical connections. Finally, support the transmission with a jack, unbolt it from the engine, and carefully slide it out from under the vehicle.
Remove the transmission pan underneath and it's inside of it.
10 W 100 oil.
Ford's Probe shared its chassis and powertrain with Mazda's MX-6. So these 2 cars have the same transmission. The Mazda 626 may have the same transmission but not sure about that one.
On a 1990 Mazda MX-6 with a manual transmission, the neutral safety switch is typically located on the transmission itself, near the shifter linkage. It may be mounted on the top or side of the transmission housing. This switch ensures that the engine can only be started when the transmission is in neutral or park, preventing accidental starts in gear. Always refer to the vehicle's service manual for the exact location and procedure for inspection or replacement.
At the rear of the engine, directly in the center, just above the transmission. If you look to the right of your firewall, you can find it by tracing the left heater hose down to the back of the engine. This answer is applicable for 1990-2005 Mazda Miatas.
On a 1990 Ford Ranger , 5 speed manual transmission : It depends on which transmission you have The Mitsubishishi ( transmission code " D " ) takes approximately ( 2.4 U.S. quarts of 80-90W gear lube ) The Mazda ( transmission code " M " ) takes ( 2.8 quarts of MERCON automatic transmission fluid )
The HOLD light means you have an electrical problem with your transmission. See your mechanic ASAP.