0
What else can I help you with?
Where's the block heater on a 1992 Mazda Protege?
My 92 Protege didn't have a block heater, I had to get one installed.
Can a single overhead head for a 1992 Mazda protege work can on a double overhead block for a 1992 Mazda protege?
DONT BE STUPID
Can a cracked engine block in a 2001 Mazda Protege be repaired?
no u cant you have to buy another block
Where is the block heater cord on a 2001 Mazda Protege?
There probably is not one, because block heaters are not installed by the manufacturer.
Where is the block heater in a 2003 Mazda Protege?
Right Rear of engine block. Above Alternator, Below coolant drain plug
Where is the heater relay on a 1995 Mazda Protege?
The relay is H270 above the fuse block next to the clutch pedal.
Where is transmission in a Honda?
Attached to back of engine block.
Can a block heater be installed in a 2000 Mazda Protege?
I had one installed on the 99 model at a shop. this is the same run line, 99-03.
Where is the alternator found at in a 1991 Mazda protege DX?
It's right there. you can't miss it, on the top right hand side of the engine block. did you look?
Will a rx-7 rotary engine fit into a Mazda 98-99 Mazda protege?
Yes, the engine block of the 13B rotary engine wieghs about 85-100lbs. its very small, most likely smaller than the 4cyl in the Protege. i know because i own 3 rx7's. hope this helps.
Will a turbo 400 transmission previously attached to a 454 big block engine attach to a 350 small block engine?
yes
Does Anybody know where the IAT sensor on a 2003 Mazda Protege 2.0L is?
IT'S BEHIND THE MASS AIR FLOW SENSOR AND THE FUSE BLOCK ON LEFT SIDE OF ENGINE COMPARTMENT
