Did it break close to the boot (point closes to the plug)? Be more specific with your question.
Spark Plug Wires? Remove them 1 at a time from the spark plug to the distributor or the ION pack, remove and replace the spark plug, add the new spark plug wire from the newly added spark plug to the distributor or ION pack.
You can change the spark plugs on the 1997 Toyota Tacoma yourself. Remove the ground wire and spark plug wire. Remove plug. Replace the plug with a plug made specially for your model car.
You won't need a diagram if you change one spark plug wire at a time.
Change one wire at a time. Take the wire from the distributor then the spark plug end, replace with wire of same length. As you do this compare wire lengths and you will be able to change them without any trouble. BE SURE THE SPARK PLUG END BOTTOMS WHEN YOU INSTALL IT OR YOU WILL GET A MISS IN THE FIRING.
Changing the spark plug wires in your 1999 Mercedes-Benz is quite simple. The spark plug wires simply lift off. The new spark plug wires can be pushed onto the spark plug. It is best to change one wire at a time.
Used proper sized spark plug socket with long extention and ratchet. Disconnect spark plug wire by using wire puller or tugging at boot of wire. Place spark plug socket over spark plug securely and removed.
Spark plug wire not connected to spark plug? Spark plug wire connected to Wrong spark plug? Vacuum line disconnected? Bad spark plug or wire?
Change the spark plug and spark plug wire. Change the fuel filter. Change the air filter. Change the motor oil.
To change the spark plugs in a Chevy Celebrity: 1. Give the spark plug boot a twist to free it up from the spark plug, then pull on the boot to remove the spark plug wire from the spark plug. 2. Use a 5/8" spark plug socket with an extension and ratchet or breaker bar to loosen then remove the spark plug. 3. Set the gap on the new plug to .045" then screw it back into the spark plug hole in the head. Tighten the spark plug and replace the spark plug wire. I change the spark plugs one at a time to keep from getting the spark plug wires on the wrong spark plug.
Pull wire off the spark plug
By taking the spark plug wire off, and then using a spark plug socket with a ratchet and extension. It's not rocket science.
In order to change the spark plug wires in a Toro lawn mower, the engine housing should be removed. The spark plug wire will then be disconnected which is a simple twisting movement under pressure. This is a very quick procedure.