answersLogoWhite

0

The sensor is left bank 1/1 is ft and 1/2 is the rear

NEW ANSWER: Bank 1 is the drivers side of the engine. Sensor 2 will be the second sensor in the exhaust pipe on that side of the engine. Start were the exhaust pipe bolts to the engine and work your way down the pipe until you see the second sensor and that will be the 1 you need.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Code for PO137 Bank 1 sensor 2 Where is this sensor located on 04 Ram 1500?

Same bank as cylinder # 1 and rearmost sensor behind converter (downstream)


What does obd11 code po137 mean?

Heated Oxygen Sensor (HO2S) Circuit Low Voltage Bank 1, Sencor 2


Code for PO137 bank 1 sensor 2 where is this sensor located driver or passenger side on 04 dodge ram?

Sounds like a clooged filter or a weak fuel pump. Replace the Fuel Filter. Install a fuel pressure gauge on the fuel rail and check it under load. If the pressure drops even a little the fuel pump is bad.


How do you fix code P0137 Jeep Liberty 2004?

PO137 (Sensor Circuit low voltage Bank 1 Sensor 2) This is the O2 sensor behind the Catalytic Converter on the driver's side. Check the wiring on that sensor before proceeding. More than likely replacing that sensor will solve the problem especially if you have over 75,000 miles on the vehicle. But there is no guarantee that will fix it.


Where is the 02 sensor heater circuit bank 2 sensor 2 located on a 2000 Dodge Durango located it has the 4.7?

Bank 1 is the bank of the engine that contains #1 cylinder. Bank 2 is the other bank. Sensor 1 is located before the catalytic converter. Sensor 2 is located after the cat converter.


Where are the oxygen sensors located on a 1996 blazer where is sensor 3 bank one?

I have a code DTC P0154.Bank 2 Sensor 1 no activity.Which sensor is this on my 96 Blazer?


Where is the o2 sensor bank 2 located on the dodge stratus 01?

Disconnect one of the 02 sensors and read the newly generated code. Then reconnect it and erase the code. Read codes again the new Bad 02 sensor code should disappear. Hence the code that followed your procedure will be for bank 1 or 2. You know which sensor you just disconnected and the new code has then identified what bank it resides in so then you will know which bank is which. You can bet real money on that.


Code P0138 comes up on your Dodge 1500 with a 5.7 liter High voltage bank 1 sensor 2 Can someone tell you which sensor that is and where it is located?

Bank 1 driver side sensor 2 rear sensor. Good luck


Where is a 2002 Mercury Mountaineer oxygen sensor heater circuit bank 2 sensor 2 with a code of P0161 located at?

left side of the engine after the cat


What is fault code Po156 on Ford Taurus?

That code indicates a fault in the 'downstream heated O2 sensor' , bank 2.That code indicates a fault in the 'downstream heated O2 sensor' , bank 2.


What oxygen sensor should you get for a malfunction code PO155 for a 2002 Mitsubishi Montero Limited and where is the sensor located for repair?

P0155 = O2 sensor heater circuit malfunction (Bank 2 Sensor 1). All O2 sensors are threaded into the exhaust system at various points. Bank 2 would be the bank of cylinders that does not contain the #1 cylinder. Bank 2 Sensor 1 would be the first O2 sensor leading from bank 2 of the engine.


What is the obd code p0340?

Camshaft Position Sensor A - Bank 1 Circuit Malfunction Trouble code P0340 means: Camshaft Position Sensor A Circuit (Bank 1 or single sensor)