No, there are different types of coolant though so make sure you use/refill with something that is compatible with the liquid already in your system. If you use two different types of coolant they may clog up or end up not functioning as it should.
No, different bolt pattern.
Yes, the 1992-96 Honda Preludes have interference motors.
If they have the exact same engine yes, otherwise no.
Not without electrical work. The 1997+ Preludes have OBD2 wire harness while the 92-96 Have OBD1. Different wire harness/sensors/ecu.
The fuel tank capacity is 15.9 gallons for the 4th gen (1992-96) Honda Prelude.
According to a chiltons manual for a 96-00 prelude the firing order is 1-3-4-2
It depends on what kind of VTEC motor is being swapped into a 1996 Honda Prelude. The H22 series certainly can be swapped in, as it was in the higher trim lines of both 4th and 5th generation Preludes.
it uses dexcool coolant
On/by the Throttle body, should read "sensor assy map"
Yes it is very tight and you have some fabrication work to do, but if you are very good and mechanically inclined it can be done.
yes
If the 96 Transmission is a 5speed and the 2001 prelude is a 5speed, the mount from the 2001 Transmission should bolt up to the 96 Transmission and be a Direct Bold on Replacement.