yes, some of them, but not all.
Sorry..there is no cabin filter for protege..mine is 2000 model.
Replace the Flasher Relay.
Hi! The fuel doors are not the same size.
No, you'll need an intake hose for either a 97 or 98
The horn fuse is the same as the stop lamp fuse
Well I had a 1995 Protege but I think is on the same place. It's beehint the right corner of the front cover. You have to remove the black cover under the car to see it. Mazda hide pretty well.
Yes, you can use SAE 5W30. Mazda recommends it in cold climates.
you have 2 horns' both close to the head litghts on left and right side
You could if you had 1992, 1993 or 1994. 165/80/13 will be your best bet.
There are two posts on the starter solenoid when the starter is in position the top one is for the positive battery cable. The bottom one should have a very short cable that enters the starter casing. I just replaced the starter in my 98 mazda protege yesterday.
Yes, the engine block of the 13B rotary engine wieghs about 85-100lbs. its very small, most likely smaller than the 4cyl in the Protege. i know because i own 3 rx7's. hope this helps.
As far as i know the block and head on the earlier model 626's(96-98)also work....is the same engine,the only difference is the intake manifold(which the 2000 626 one is an upgrade for the mzdaspeed protege)and the ignition which is different than the coil-on-plug on the protege////