No it doesn't
I bought a 2009 accent as well. Found myself asking the same question. I called the dealership and the answer was NO.
There are a couple of ways to open the trunk on a Hyundai Accent. The trunk can be opened by using a key or by using the hood release latch inside the car.
that's a very general ?, but pcm, fuel pump, fuel filter, do u have a chip in ur key?, How do u know ur not getting fuel?
No it doesnt. I had the same question because I needed to get a copy of my key made so I went to the dealership to make sure it didn't and they told me it didn't! Money saved!
The 2005 Hyundai XG350 does not have a traditional chip key system. Instead, it uses a standard metal key for ignition. However, some models may come with a remote key fob for keyless entry, but this does not include a transponder chip for the ignition. Always check the owner's manual or consult a dealership for specific information regarding your vehicle's key system.
The dealer scan tool is required.
There should be a slot on the dash marked passenger airbag. You will have to use the ignition key to turn it on.
Buy one Steal one Borrow one Make one 4 Suggestions, get on with it :) If it has an embedded immobilizer chip and you don't have the original, you will need to get one from a Hyundai dealer. If you have the original, a lot of key cutting shops have the ability to clone it. Either way, it's expensive.
From a dealer with the VIN, You will probably have to show proof of ownership.
No it does not have a chip in the key. www.keylessride.com
The 2010 Chevy Aveo LT typically does not have a transponder chip in the key. Most models of that year use a standard metal key without any electronic components. However, it's always advisable to check the owner's manual or consult a dealership for specific information regarding your vehicle's key system.
Not all Hyundai cars has codes. if there is one, it will be stamped on the passenger's door cylinder. the best way to make a key for this cars is to have a locksmith come and disassemble the cylinders in order to get the right cut depths <a href="http://www.locksmithinla.com">Locksmith</a>