The first thing I do before replacing head gasket is have a machine shop check and resurface head if needed. Cost +-$100 Usually gasket goes bad do to warped head. Make sure you tighten them in order by drawing a rectangle, label one end "FRONT" number one side from front 8 4 1 5 9 then # other side from front 7 3 2 6 10. tighten 1-10 this will start you in middle. First tighten them to 59 ft-lb, second tighten them to 64 ft-lb, third 64 ft lb again.
The 2002 Kia had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.
what is the torque cylinder head bolts and the camshaft for KIA clarus 2.0 petrol DOHC 1998 model
Kia what ? sportage ? Rio ? serento ?
The 2000 Kia 2.0 liter engine cylinder head bolt torque specification is 125 pounds. The cylinder head bolts should be torqued in 25 pound intervals.
64 ft lb
headbolt torque is : 62 ft/lb cam hold down bolts is : 13 to 20 ft/lb
Best to replace - after initial torque setting it is difficult to get an accurate setting a 2nd time (threads have been stretched)
http://wiki.answers.com/Q/What_are_the_torque_settingsand_tightening_sequence_for_the_cylinder_head_bolts_on_a_kia_sedona_2.9 the cylinder head bolts on a kia sedona 2.9?"
exhaust manifold to head nuts are 31 ft. lbs.
I need to know the timing marks for when I put both the cam shafts back on and the head torque specifications for a 1997 KIA Sportage, two wheel drive.
The 2008 Kia Sportage has 39.4 in. of rear head room.
The 2013 Kia Sportage has 39.1 in. of front head room.