This is a classic case of internal clock failure. We offer a reasonable repair service at www.autoclockrepair.com
If the clock is not working, it is most likely an internal problem with the clock itself. Check out the below site:
I would try a clock repair shop.
There are no batteries for the CR-V dashboard clock. The clocks were manufactured with Liquid Crystal Diodes (LCD's) and when they burn out or go dark, the entire clock must be replaced.
To set the clock on a 2010 Honda Odyssey, first, turn on the vehicle and locate the clock display on the dashboard. Press and hold the "Clock" button until the time begins to flash. Use the "H" (hour) and "M" (minute) buttons to adjust the time accordingly, then press the "Clock" button again to save the settings.
To set the clock in a 2011 Honda Pilot, turn on the ignition and press the "Menu" button on the dashboard. Use the navigation dial to select "Clock" and then choose "Set Clock." Adjust the hour and minute using the dial and confirm your settings. Finally, press the "Menu" button again to save the changes.
On a 1999 Honda Accord you can pop the clock assy out and replace the samll bulb. It's Sunday so the dealers are not open and I'm searching for the bulb now.
how do you reset the clock on a 2005 Honda accord how do you reset the clock on a 2005 Honda accord
In my 1997 CR-V, there is no clock fuse listed on the fuse box. By the way, when my clock lamp (LED?) stopped working intermittently, my UK dealer explained that the clock was a sealed unit and was very expensive to replace. My clock lamp finally failed completely (the clock may be okay ... I cannot tell). I fitted a new cheap clock to the dashboard, using the gap around the factory clock to host the screws. I also eventually bought a new audio unit with a clock display.
To set the clock on a 2005 Honda Civic, first, turn on the ignition. Press and hold the "Clock" button on the radio or dashboard until the display starts flashing. Use the "H" (hour) and "M" (minute) buttons to adjust the time accordingly, then press the "Clock" button again to confirm the setting. The new time should now be displayed.
To replace the clock light bulbs in a 2000 Honda Passport, first, disconnect the negative battery terminal for safety. Remove the trim panel around the dashboard clock by gently prying it off. Unscrew the clock assembly to access the bulbs, then carefully twist and remove the old bulbs. Replace them with new ones, reassemble the clock, and reconnect the battery.
To replace the clock light in a 1999 Honda Passport, first, disconnect the vehicle's battery to ensure safety. Remove the clock assembly by carefully prying it out of the dashboard. Once removed, locate the bulb socket at the back of the clock, twist it counterclockwise to remove the old bulb, and then replace it with a new bulb of the same type. Reassemble the clock and reconnect the battery to test the new light.
The code in clubpenguin for Clock Repair, I think it is the word "key" ! Keep working hard