answersLogoWhite

0

Pop off the long inner trim strip (wood or aluminum) w/ a knife. You will see 2 screws near the center of the door, remove them. Remove the small (1.2 inch square) square plastic screw cover behind the inner door lever, and remove this screw, then gently remove the plastic trim surround. Carefully pop up the trim cover to the electric window control, lift up, then disconnect the electric control module. Then beginning at the bottom of the panel, using an upholstery tool, or a thin flat screwdriver (putty knife works well), gently lift the panel away from the door. There will be 2 clips at the bottom, and 1 each on each side. Once you have popped these out of their holes, the panel then lifts upward. Then disconnect the puddle light at the bottom of the panel, and you are done. Time involved...5 minutes.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove the door panel on a 2000 Bonneville to fix the window door regulator?

i have a 04 and the door panel comes off easy like on most cars it has little screw clamps witch you just pop out. use some hard flat plastic wedge to get the door panel off.


How do you remove door panel on 04 avalanche?

To remove the door panel on a 2004 Chevrolet Avalanche, first locate and unscrew any visible screws or fasteners holding the panel in place. Next, gently pry the panel away from the door frame using a trim removal tool or a flathead screwdriver. Be cautious not to break any clips or connectors holding the panel in place. Once the panel is detached, disconnect any wiring harnesses before completely removing it.


How do you remove a door panel from your Nissan Murano 04?

You would need to remove the screws from behind the inside door handle and also the door pull. Then you should be able to pry the door panel off with a door hanel removal tool, or you can also use your hand. I've also included a link to an instructional video below, that will show you all of the steps that need to be taken.


How do you remove the interior panel on the inside of the door for access to the exterior side mirrors on a '04 F-250 or Excursion?

I THINK THERE IS A SCREW IN THE DOOR CLOSING HANDELE AND UNDER THE SWITCH PANNEL.


How do you replace rear door window 04 silverado?

To replace the rear door window on a 2004 Chevrolet Silverado, first, remove the door panel by unscrewing any visible screws and gently prying off the panel clips. Next, disconnect the window regulator and any electrical connectors. Carefully remove the broken glass pieces and install the new window by aligning it with the regulator. Finally, reassemble the door panel and test the window to ensure it operates correctly.


How do you remove the door panel from a 2002 Chevy Silverado truck with power door locks?

I just removed the passenger side door panel of my '04 silverado 2500 w/power locks & windows. Yours may be slightly different. 1) Remove the triangular piece above the door panel by prying out the two corners closest to you (the third corner hooks in, you don't want to breal the hook. 2) Pry out the small odd shaped panel that surrounds the handle. Remove the screw that you exposed. 3) Pry out the manual lock escution. 4) Remove the exposed screw just above that panel. 5) On the bottom of the door panel is a single exposed screw. Remove this screw and pry out the door pockets. Note: The previous steps can be done in any order. 6) This step is a little more trickey. Pry out the end of the electric lock panel that is away from the door hinge. Do not try to pry out the other end, it is held in w/a screw on the inside. 7)Now lift the door panel up and off its hooks. 8)Disconnect the speaker wire (if any) and unscrew the screw that holds the hinge end of the power lock panel. 9) Pass the panel through the hole to free it. 10) Now you just have to disconnect the door step light (use a screwdriver to depress the locking tab) and you are home free! Good luck


How do you replace a mirror 04 endeavor?

To replace the mirror on a 2004 Endeavor, first, carefully remove the interior door panel to access the mirror's mounting bolts. Disconnect the electrical connector if the mirror is powered. Unscrew the old mirror from the door, then attach the new mirror by aligning it with the mounting holes and securing it with screws. Finally, reattach the door panel and reconnect any electrical components.


How do you remove the driver inner door panel on a 2001 Chevy silverado 2500 HD 4x4?

I just removed the passenger side door panel of my '04 silverado 2500 w/power locks & windows. It's a little more complicated than the previous post. 1) Remove the triangular piece above the door panel by prying out the two corners closest to you (the third corner hooks in, you don't want to breal the hook. 2) Pry out the small odd shaped panel that surrounds the handle. Remove the screw that you exposed. 3) Pry out the manual lock escution. Remove the screw that you just exposed. 4) On the bottom of the door panel is a single exposed screw. Remove this screw and pry out the door pockets. Note: The previous steps can be done in any order. 5) This step is a little more trickey. Pry out the end of the electric lock panel that is away from the door hinge. Do not try to pry out the other end, it is held in w/a screw on the inside. 6)Now lift the door panel up and off its hooks. 7)Disconnect the speaker wire (if any) and unscrew the screw that holds the hinge end of the power lock panel. 8) Pass the panel through the hole to free it. 9) Now you just have to disconnect the door step light (use a screwdriver to depress the locking tab) and you are home free! Good luck


Driver side panel wont work on jeep grand Cherokee Laredo 04?

The 04 is common for this if you are referring to the door panel. The wires rub the inside of the opening where it runs out of the door into the hinge area...causing it to break. If you pull the panel and inspect each wire, you will probably find one broken or shorting out against metal....so all you have to do is splice it.


The windows on a 04 Malibu stopped working does anyone have any suggestions?

Check the fuse in the panel on driver side door


Will a door from a 1994 z24 fit a 2000 z24?

No only 1995-2004 will work Pontiac sunfire doors from 95-04 will work also but the door moulding and door panel will need to be changed


How do you remove the rear panel drivers side of a 03 Honda CR-V to access the trailer wiring connection?

I pulled the panel off of my 04 Honda CRV and could not locate the connector:(