answersLogoWhite

0

Simple check is to ground the fuel sending wire at the fuel tank.If the gauge reads FULL then it is a bad fuel sending unit and you need to drop the fuel tank to replace it.If the gauge reads empty when you ground the wiring then it means you have a bad fuel gauge.I would lean strongly towards the sending unit be bad my 87 the gauge started reading about 1/4 tank less before it failed.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you replace fuel pump 92 Mazda pick up B2200?

How do you replace fuel pump 92 Mazda pick up B2200?


How do you fix a 92 Thunderbird that starts and runs weakly then dies when the gas pedal is depressed?

By A Chevy


How much pressure on electric fuel injection fuel pump for 1992 b2200 Mazda pickup?

92 b2200 ,fuel injection psi should be 38 to 46 psi


How can you fix gas and temperature measurers of a Nissan pick up 92 that doesnt work anymore?

yeah


Where is fuel pump on 92 Mazda B2200 truck?

If it is a factory fuel injected the fuel pump is in the gas tank, if it is a factory carburated the machanical fuel pump is at passenger side rear of the engine head.


Oil pressure for 92 b2200 Mazda?

The attached links should answer you're question. Kyrasis6 Mazdatruckin.com


What is the usual lifespan of a 1991 Mazda truck?

I have a 92 b2200 with 325k miles. Ibought it brand new.


Why would a Gas gauge on a 92 geo not work properly?

A corroded ground connection on the wires for the fuel tank harness can cause the gas gauge on a 1992 GEO to not work properly. The wires are located under the back seat inside the vehicle.


How do you fix the engine temperature gauge on a 92 Chevy silverado?

Check the sending unit between the left first 2 spark plugs. Ground the wire with key on (gauge should peg full hot). If it does change the sending unit.


How do you fix the fuel gauge on the 92 Lincoln mark VII?

most failures lead to the fuel sending unit inside fuel tank.and yes the tank must come out


Can you put a 87 Mazda 2.0 engine and tranny in a 92 b2200?

no problem, you may have to change the motor mounts but its the same transmission...


How do you use scan on Mazda 92 b2200?

The B2200 does not have "scan tool" capability. It does have a diagnositics port that can be used to throw out codes using the MIL light in the dash. There are about a dozen codes that at best tell you the obvious. There is lots of help on mazdatruckin.com that can help you diagnose your truck.