# With the car started (ignition on), set the LCD odometer readout to total mileage (not trip A or B). # Turn the car off (ignition key to the OFF position). # Push in AND HOLD the button/knob that switches the odometer # Turn key to ON position without starting the car. You will notice the maintenance light blink and go out. # Release the odometer button/knob. # Turn key to OFF position. # That's it! The "MAINT REQD" light has been reset to warn you to change your oil in another 5,000 or 7,500 miles or so.
A person can reset the maintenance required light on a 2004 Toyota Sienna by holding down the odometer trip button. A series of zeroes will appear, which indicates that the light has been reset.
How do you reset maint read light on 2010 corolla
How to Reset the "MAINT REQD" Light on Toyota Sienna With the car started (ignition on), set the LCD odometer readout to total mileage (not trip A or B). Turn the car off (ignition key to the OFF position). Push in AND HOLD the button/knob that switches the odometer Turn key to ON position without starting the car. You will notice the maintenance light blink and go out. Release the odometer button/knob. Turn key to OFF position. That's it! The "MAINT REQD" light has been reset to warn you to change your oil in another 5,000 or 7,500 miles or so.
Maint. required light want reset.
1. Ensure odometer is showing total miles (not one of the "trip" miles). 2. Turn the ignition key to the "OFF" position. 3. Push the trip odometer reset button and hold it "in." 4. WHILE HOLDING DOWN THE RESET BUTTON, turn the ignition key to "ON" and continue to hold the reset button down until the odometer reading shows "------" and the "maint required" light goes off (about 5 seconds). 5. Release the reset button and total miles will return and the maint required light stays off! I got this answer from WikiAnswers for the 2004 Sienna. If my answer doesn't make sense, look at that guy's.
After repairing the cause of the code, you can clear it with a scan tool.
The easiest way to reset the 2001 Toyota check engine light is to remove the check engine light fuse. The fuse can be found in the fuse box.
When there is an issue with a vehicles airbag, the airbag light comes on. In order to reset it, the problem must be taken care of, and reset by a computer.
Maint Req lite oil change notification...reset as follows. Get in van and close the door. Turn key on (not start) and indicator lites will come on. Select total miles on odometer...not trip A or B. Turn off key. Press and hold down odometer selector and turn on key (not start) and lites will come on again...but Maint Req lite will reset and go out. Turn off key. Maint Req lite will come on again in 7500 miles...just change your oil regularly...and reset as needed.
Set it to trip A and hold reset turn ignition off then turn ignition on and maintenance light will flash and your done.
You can reset the check engine light on a Toyota by removing the battery cables and touching them together. Other than that, you will have to take the car to a mechanic and have them run a scan tool to turn the light off.
My reset button is on the lower left hand side of the panel below the steering wheel