there is a small long bolt on the left side of the brake handle tighten the nut to adjust
ckeck for vac. leak at brake booster
well i just changed the brakes on my Mazda mx3 what you do is take the 2 pins out of the calipers which is holding the pads in place and then you are able to remove the pads
I haven't been able to find.
Right hand thread
The flasher box in the Mazda MX3 is the plug in that controls the flashers for the turn signals and also the hazard lights. This part is located under the dash on the driver's side, just above the brake pedal area.
it uses the "extra" fluid from the brake reservoir, so just check that you are ok on brake fluid and your clutch should be fine
The neutral safety switch, release switch, or brake switch is bad.
What are the head bolt torque specs for a mazda mx3 1600
Adjust your shift linkage or just pay attention to how many clicks down you are going
you have to open the hatch, take all the plastic interior apart, just to get to your bulbs. its a pain.
You can't. Mazda MX-3's have Hydraulic clutches which work like an on/off button as opposed to the standard cable based clutches.
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.