answersLogoWhite

0

Get down on the floor board and look up at the brake pedal arm. You will see a switch that the arm hits when no pressure is applied to the brake. Twist the switch and adjust so when you barely touch the pedal the brake lights come on.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How to change 2002 Nissan Altima brake light?

how to change a brake light on 2002 Nissan altima


How do you change brake switch on 2000 Nissan Altima?

Get down on the floor board and look up at the brake pedal arm. You will see a switch that the arm hits when no pressure is applied to the brake. Twist the switch and pull out of bracket and then remove wires. Do reverse when installing new switch adjust so when you barely touch the pedal the brake lights come on.


How do you replace brake light switch on a 2000 Nissan altima?

To replace the brake light switch on a 2000 Nissan Altima, first disconnect the negative battery terminal to ensure safety. Then, locate the brake light switch, which is typically found above the brake pedal. Remove the electrical connector from the switch and unscrew it from its mounting bracket. Finally, install the new switch by reversing the removal steps and reconnect the battery.


How do you repair brake light being stuck on for a 1996 Nissan Altima?

Check brake light switch - could be defective or not aligned properly


How do you adjust brakes on a 2000 Altima GXE?

All of the brake pads on your 2000 Nissan will have adjustment nuts. You can turn the adjustment nuts to tighten or loosen the brake pads.


Why is your brake light staying on in your Nissan Altima?

low brake fluid


What type of brake fluid is needed for a 2007 Nissan Altima?

According to the owners manual for Nissan Altima 2007 it is DOT 3.


I own a 2003 Nissan Altima my shifter is stuck in neutral and can't move it?

Try to have your Neutral Safety switch checked out or your brake switch, It controls the shifter so you cant put it in gear without pressing the brake


When you turn off your 1994 Nissan altima the brake lights are still on how can you fix this problem?

Most imports have a rubber plug in the brake pedal arm.It hits the brake light switch to turn it of.Look in the floorboard for pieces of rubber.If this piece came out,tou can put a flat screw in its place.If you use a screw you will need to un-screw the brake light switch 1-2 turns to adjust the switch so the brakes dont lock-up.


Why the stop lights on a Nissan altima 1993 stay on all the time?

There could be a few reasons why the stop lights on a Nissan Altima 1993 are staying on all the time. It could be due to a faulty brake light switch, a short circuit in the wiring, or a problem with the brake pedal sensor. It is recommended to have the vehicle inspected by a mechanic to diagnose and fix the issue.


Does the 2004 Nissan Altima have the same brake pads as a 2007 Nissan Altima?

Most likely not as those 2 models are total different generations.


How many sensors does the brake pads have for a 2003 Nissan altima?

brake light and battery light is on