answersLogoWhite

0

loosen the three bolts on the distributor and turn it, that will change your timing. Timing belt change intervel is 100,000km or 5years.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you fix the timing belt for a acura integra gsr none vtech?

The GSR always had VTEC. Do you want to adjust your Timing, or replace the Timing Belt?


How do you replace the timing belt on a 90 acura integra ls?

With a screwdriver.


How do you change the alternator in a 1995 Acura Integra?

how do you replace an alternator on a 1990 integra


How do you set the timing on a 1999 Acura integra?

To set the timing on a 1999 Acura Integra, first ensure the engine is at TDC (top dead center) on the compression stroke for cylinder one. Then, locate the timing marks on the crankshaft pulley and the timing cover; align these marks to 0° BTDC. Adjust the distributor to align the rotor with the designated timing mark, and secure it. Finally, check the timing with a timing light to ensure it is within the specified range.


How do you adjust timing on 1991 Acura Integra?

To adjust the timing on a 1991 Acura Integra, first, ensure the engine is at operating temperature, then turn off the engine. Locate the timing adjustment connector, usually found near the driver's side of the engine bay, and short it with a jumper wire. Start the engine again and use a timing light to check the timing mark on the crankshaft pulley against the timing specification, adjusting it by loosening the distributor and rotating it until the timing aligns correctly. Finally, remove the jumper wire and recheck the timing.


Do you have a 1993 integra timing belt diagram?

Fot the 1993 acura integra timing belt 'cord' specifications. Is the honda made timing belt from fiberglass or kevlar ?


How much shoud it cost to replace an alternator for your 1988 acura integra LS?

Hou much should it cost to replace an alternator for a 1988 acura integra Ls?


What happens if the timing is of on a timing belt on an Acura Integra?

Most likely your car wont start.


How do you set the ignition timing on a 1989 Acura Integra?

Ignition timing is set on a 1989 Acura Integra by setting the distributor to the appropriate angle. When set at the factory recommended angle the car will turn over with no problems.


How can you tell if the timing is bad on a 1990 Acura Integra and how to reset it?

If timing is bad on a 1990 Acura Integra they car will either run incredibly rough out not at all. To fix the timing be sure to correctly align the distributor to the right factory specified degree.


Can a 1.6l replace the 1.8l in Acura Integra?

yes but you will be disappointed


Where is the water pump on a 97 Acura Integra?

behind the timing belt cover