answersLogoWhite

0

To bleed the hydraulic clutch on a 1997 Isuzu Trooper, first ensure the reservoir is filled with the appropriate brake fluid. Locate the bleeder valve on the slave cylinder, usually found near the transmission. Attach a clear hose to the valve and place the other end in a container to catch fluid. Have an assistant pump the clutch pedal several times, then hold it down while you open the bleeder valve to release air. Close the valve, repeat the process until no air bubbles appear in the fluid, and finally check and top off the fluid level in the reservoir.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

How do you change the clutch slave cylinder on an Isuzu trooper?

To change the clutch slave cylinder on an Isuzu Trooper, first, safely lift and secure the vehicle. Remove the old slave cylinder by disconnecting the hydraulic line and unbolting it from the transmission bell housing. Install the new slave cylinder in the same position, ensuring a proper seal, and reconnect the hydraulic line. Finally, bleed the clutch system to remove any air, and check for proper operation before lowering the vehicle.


On a 1990 Isuzu Amigo what would cause the clutch pedal to stick to the floor?

if its hydraulic there could be air in your line. bleed your clutch and refill.


How do you get a hydraulic clutch on a 1986 C1500 working?

try to bleed the clutch


How do you bleed the hydralic clutch 2000 Isuzu amigo?

To bleed the hydraulic clutch on a 2000 Isuzu Amigo, start by ensuring the vehicle is on a level surface. Locate the clutch master cylinder and fill it with the recommended hydraulic fluid. Next, have a helper press the clutch pedal several times and hold it down; while they do this, open the bleeder valve on the slave cylinder to release any air and fluid. Close the valve before your helper releases the pedal, then repeat the process until no air bubbles are present in the fluid.


How do you adjust the clutch on a 1997 Subaru?

It probably has a hydraulic clutch so you will have to bleed the air out of it.


How can you bleed the hydraulic clutch on my 88 bronco 2?

Dumdassesssssssssssss!


How do you bleed a hydraulic clutch system on a gmc sierra?

shhould be da same way u bleed your break system... bleed valve on clutch master cylinder...


How do you bleed hydraulic clutch 92 rodeo?

pray like hell


How do you bleed a hydraulic clutch on an Audi 4000?

The rubber gasket failure.


How can you bleed a Rover 400 1998 hydraulic clutch?

The Hydraulic clutch fitted to the rover 400 is a sealed unit and the only thing that you can do is to replace the complete unit


How do you bleed a clutch on opel astra gtc?

Follow the clutch hydraulic line down to the bell housing. Note where the hydraulic line goes into the bell housing and if there is no bleed valve there you may need to remove a cover. Have a friend/assistant step on the clutch while you open the bleed valve. Close the valve and have the friend let up on the clutch. Do that a few times (making certain that the hydraulic fluid remains full) and you're done.


How do you bleed the hydraulic clutch on 1996 Toyota tacoma 4x4?

figured it out. thanks anyways.