answersLogoWhite

0

Basically, Remove the rear wheel, remove the wheel bearing cap from the front of the hub. make sure the handbrake is off. so you can get the hub off, Remove the split pin from the nut and then undo the nut. the front bearing will slide out and then to check the rear bearing you will have to remove the rear seal without damaging it, but because its plastic with a steel insert inside it will probably be damaged. Check out the bearing clean and dry but dont dry with compressed air as they will be damaged by spinning without grease. repack bearing or replace and repack bearings, insert new seal and then put hub back on stub axle push all the way on, then put on the outer bearing, allatc washers and nut, tighten nut still allowing the hub to turn without sloppyness, put on grase cap. and your done. Pacnat1

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you change rear wheel bearings on 1978 Corvette?

How to remove rear wheel bearings on a 1978 corvette..?


Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier?

Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier


How to replace rear wheel bearings Chevy aveo?

How do you change the wheel bearings on a Chevrolet aveo 2005


How do you change KIA rear wheel bearings?

very carefully with great intent


How do you change the wheel bearings on a 1995 Geo Prizm?

Front or Rear? Both


Ho w do i change rear wheel bearings in '89 Chevy 1500?

WOW! Wish I could help you with this one but I didn't even know Chevy had rear bearings on rear wheel drive trucks.


How to change wheel bearing on a 2004 Lincoln aviator?

How to replace rear wheel bearings on Lincoln aviator


How do you pack the rear wheel bearings on a 2002 Toyota Avalon?

you don't they are sealed bearings. they will need pressed out of the hub to change them.


How do you change evo vi rear wheel bearings?

To change rear wheel bearings on an Evo VI, jack up the car and remove the transmission tray. Also remove the engine tray and plastic cover of the suspension wishbone. Remove the rear wheels and the axle nut. Take the brake pads off and loosen the screws of the rotor. Remove the hub and the rear wheel bearings. Replace.?æ


How do you change rear wheel bearings on dodge charger?

To change the rear wheel bearings on a Dodge Charger, start by safely lifting the rear of the vehicle and securing it on jack stands. Remove the wheel and brake components to access the hub assembly. Using a socket set, detach the hub from the axle and remove the old bearings. Install the new bearings in the hub, reassemble the components in reverse order, and ensure everything is tightened to the manufacturer's specifications.


How to change rear wheel bearings Mercury Tracer?

What year tracer? Some you need special tool to pull bearings and hub as a unit!


How do you change wheel barrings on a mercury villager?

The front wheel bearings need to be pressed into the spindles. This is something an automotive machine shop would normally do. The rear wheel bearings are bolt-on hub assemblies.