0
What else can I help you with?
How do you change a CYP cylinder position sensor on a 1996 Honda Accord 2.2?
Here is what i know the (CYP) cylinder sensor is deep in the distributer and the easiest way to fix it is, Change the distributer. !
Where is the water temp sensor on a 1998 Honda accord 4 cylinder located?
The coolant temperature sensor on a 1998 Honda Accord is located next to the thermostat housing. The sensor has a blue clip located on the right side of the engine compartment.
Were is locate the cylinder position sensor in 96 Honda accord?
In the distributor
Where is the coolant temperature sensor tw located on a 1988 Honda Accord 4-cylinder fuel injected with a manual trans located?
The 1988 Honda Accord coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.
What does heated oxygen sensor bank 1 sensor 2 mean on a 2003 Honda Accord?
Bank one refers to the side of the engine that has the number one cylinder. Sensor 2 refers to the second sensor in the exhaust pipe coming from the engine, normally the one past the catalytic convertor.
How to fix Honda Accord DTC P0141 Heater Circuit Bank 1 Sensor 2?
DTC P0141 Indicates "O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 2)". Bank 1 Sensor 2 is the HO2S after the catalytic converter.On a 4 cylinder engine it is the sensor on or after cat. It could be a bad wire or a bad ecm most of the time it is the Sensor that goes bad. On a 6 cylinder engine with 4 oxygen sensors it is the bank with cylinder one, sensor after catalytic convertor.
Where is the temp sensor at 91 Honda Accord?
The water temperature sensor on your 1991 Honda accord, is located on the front of the engine. The sensor is above the water thermostat housing.
What does P1382 mean on 1996 Accord?
P1382 = Cylinder Position Sensor 1 No Signal.
Where is the heated o2 sensor 2 bank 1 located on a 2003 accord 4-cylinder?
It will be the lower of the O2s (furthest away from the engine on bank one). If its a v-6 bank 1 is usually where the # 1 cylinder is.
Where is o2 sensor located on 89 Honda Accord lxi?
The Oxygen sensor of a 89 honda accord lxi fuel injection 2.0 valve engine is located in front of the engine on the manifold .
How do you change the crank sensor on 2001 accord ex?
To change the crankshaft position sensor on a 2001 Honda Accord EX, first disconnect the negative battery terminal to ensure safety. Locate the sensor, which is typically found near the crankshaft pulley on the engine block. Remove the old sensor by unfastening any bolts and disconnecting the wiring harness, then install the new sensor by reversing the process. Finally, reconnect the battery and start the engine to ensure proper function.
Where knock sensor wire located in Honda Accord 2000 model?
In the 2000 Honda Accord, the knock sensor wire is typically located near the engine's cylinder block. The knock sensor itself is usually found on the side of the engine, often near the intake manifold or under the intake manifold on the V6 models. The wire leading to the knock sensor runs along the engine harness, making it accessible for inspection and replacement if needed. Always refer to the vehicle's service manual for specific locations and wiring diagrams.
