The bottom strut mount is connected to the frame by two retaining bolts. Remove the retaining bolts to remove the strut mount. Reverse the process to install the new strut mount.
under the hood near the LF strut mount next to the battery
E-Bay?Hemming's Motor?
The torque strut mount must come out along with the mount to remove the alternator
the same as every strut mount. to hold the struts
To remove the struts on a 2006 Mitsubishi Eclipse, start by safely lifting the vehicle and securing it on jack stands. Remove the wheel to access the strut assembly, then detach the brake line and any other components connected to the strut. Next, unbolt the top strut mount inside the engine bay and the bottom strut bolts on the control arm. Finally, carefully pull the strut assembly out and repeat the process for the other side if necessary.
there are 4, each above the strut holding the spring on
To access the top rear strut mount on a 1997 Dodge Intrepid 3.5 ES, first, lift the rear of the vehicle and securely support it on jack stands. Remove the rear seat and any trim panels to expose the strut mount access points. Then, unbolt the strut mount from above and detach the strut assembly from the lower control arm, allowing you to replace or service the strut mount as needed. Always consult a repair manual for specific torque specifications and safety precautions.
To change the rear strut on a 2002 Hyundai XG350, start by safely lifting the vehicle and securing it on jack stands. Remove the rear wheel, then disconnect the lower strut bolt and the upper strut mount bolts inside the trunk. After detaching the strut assembly, replace it with the new strut, reattach the upper and lower bolts, and finally, reinstall the wheel. Always ensure the suspension is properly aligned after completing the replacement.
To change the rear struts on a Saturn L300, first safely lift the vehicle and remove the rear wheels. Then, unbolt the lower strut mount and the upper strut mount inside the trunk, typically by removing the rear seat or trim panels. Replace the old strut with the new one, ensuring all bolts are torqued to specifications, and reassemble the components. Finally, reinstall the wheels and lower the car to the ground.
To change the torque strut on a 2007 Ford 500, start by safely lifting the vehicle and securing it on jack stands. Remove the lower engine mount bolt and any necessary components blocking access to the strut. Then, unbolt the torque strut from the engine and the subframe, replace it with the new strut, and reassemble everything in reverse order. Finally, ensure all bolts are tightened to the manufacturer's specifications before lowering the vehicle.
see link below..
Strut mount, coil spring, coil spring isolator, rubber dust boot.