0
What else can I help you with?
Where is the neutral safety switch located on a 1988 Acura Legend?
99 acura Ti
Where is the neutral safety switch on a 96 Acura Integra in order to disable it?
The neutral safety switch is located on the clutch pedal. This switched is used so as a safety so the car cannot be start in gear. Reach under the dashboard to unplug the switch from the harness.
Where is neutral safety switch located on 2007 Acura TL?
The neutral safety switch on a 2007 Acura TL is typically located on the transmission. Specifically, it is mounted on the side of the transmission case, near the shift linkage. This switch ensures that the vehicle can only be started when the transmission is in the "Park" or "Neutral" position. To access it, you may need to lift the vehicle and remove any necessary components for better visibility.
How do you install neutral safety switch in a 1997 Acura RL?
To install a neutral safety switch in a 1997 Acura RL, start by disconnecting the negative battery terminal to ensure safety. Then, remove the shift cable and any necessary components to access the switch, typically located on the transmission. Replace the old switch with the new one, ensuring it aligns properly with the transmission and adjust if needed. Finally, reassemble everything and reconnect the battery.
Where is the neutral safety switch on a 1994 Acura Integra?
On a 1994 Integra the neutral safety switch in located right above the clutch pedal under the dash(If you were to lay in the floor board with a flash light and press the clutch you should be able to see it). It's kinda hard to access because it so far up in there. so 9 times out of 10 the switch itself isn't bad there is piece of plastic that pushes in the neutral safety switch that is broken or fell off. It's cheaper and the switch will still work. I had this problem with my integra yesterday, it wouldn't start or turn over. So I had to go down the list of things it could be, then I found out where that switch was pushed it in and the car started right up no problem. Hope this was helpful to somebody. DarrenDizz
How do you change the key cylinder of the ignition switch in a 1991 acura legend?
Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.
Brake light stays on How can you FIX THIS 1991 Acura Legend?
You will need to change the brake light switch. The brake light switch can be found below the dashboard on the drivers side.
How do you change transmission in a Acura Legend?
How do you change transmission in a acura legend?
Where is the 1995 Acura Integra fan switch located?
The fan switch on a 1995 Acura Integra is located on the dashboard. It is a part of the temperature control system.
How do safety ratings for the Acura RSX compare to other cars in its class?
The safety ratings for the Acura RSX are very good,much better than most cars in its class. You can review the safety ratings for the Acura RSX and other vehicles at www.internetautoguide.com.
Where is the radiator fan switch on a 89 Acura Legend?
The 1989 Acura Legend radiator fan switch can be found on the inside of the quarter panel. You can find the switch on the drivers side quarter panel.
How do you change a 98 Acura CL alternator?
how to change alternator in acura 1999 cl
