answersLogoWhite

0

Its not too hard to change them, see related link (pictures are gone, but directions remain).

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do motorcycle rear shock absorbers work?

The most simple shock absorber design has it sit between the arm that holds the wheel and area under the seat on the frame. As the rear tire hits a bump, the shock absorber is "sandwiched" between the two. The shock absorber itself isn't too different from any other shock absorber.


Can a rear shock absorber leak oil?

Yeah, sure.


What is the rattle underneath in the left rear corner of your 2000 grand cherokee?

Could be a bad shock absorber or shock absorber bushing. Could be bad bushings on the rear sway bar (if equipped).


How do you adjust rear shock absorber in R1200C BMW?

adjust the throttle


Does rear shock absorber leak on vw polo 1.4 1996?

Yes


What is the rear shock absorber bolt size for a 2000 silverado?

The rear shocks take a 21mm wrench...


How do you install a shock absorber for whirlpool duet washer?

To install a shock absorber for a Whirlpool Duet washer, start by unplugging the washer and locating the shocks at the front and rear of the washer. Remove the screws securing the shock absorber in place, then swap out the old shock absorber with the new one. Secure the new shock absorber with the screws and plug the washer back in. Run a test cycle to ensure proper installation.


Can you put a front gas shock absorber and a rear oil shock absorber on your car?

The front and rear axle of the vehicle works independently. Unless you have different type of absorber for left and right side, if not, there will not be any harm using either gas or hydraulic on different axle. Tks


How do you change shock absorbers in 2002 dodge caravan?

# Raise vehicle. # Support the rear axle of the vehicle using 2 jackstands positioned at the outer ends of the axle. NOTE:If the shock absorber lower mounting bolt deflects upward during removal, raise axle by adjusting the support jack. If the lower shock absorber bolt deflects downward during removal, lower the axle by adjusting the support jack. # Remove the shock absorber lower mounting bolt. # While holding shock absorber, remove the shock absorber upper mounting bolt and shock absorber. # While holding shock absorber in position against the frame rail, install the shock absorber upper mounting bolt. # Install the shock absorber lower mounting bolt securing the lower end of the shock absorber to the axle. # Remove the support jack. # Lower the vehicle to the ground so the full curb weight of the vehicle is supported by the suspension. # Tighten the upper and lower shock absorber mounting bolt to a torque of 88 N·m (65 ft. lbs.).


How do you replace a jaguar xj8 rear shock absorber?

To replace the rear shock absorber on a Jaguar XJ8, first ensure the vehicle is safely elevated and secured on jack stands. Remove the rear wheel to access the shock absorber; then, unbolt the top and bottom mounting points of the shock. Replace the old shock with the new one, tightening the bolts to the manufacturer's specifications, and reattach the wheel. Finally, lower the vehicle and perform a test drive to ensure proper installation.


Shock Absorber?

form_title= Shock Absorber form_header= Replace the shock absorber in your vehicle. When do you need the shock absorber?*= _ Will you install it yourself?*= () Yes () No Do you want to purchase after-market parts?*= () Yes () No


Does Rafael nadal have a shock absorber?

Rafa does play with a shock absorber.