0
your going to need a press for the bearing, it cost me about 200 for one wheel at the auto body, that's including the 80 dollars an hour for labor and parts.
If you buy the wheel hub and bearing in one assembly its real simple to change it.
- Remove wheel
- Remove brake caliper, brakes and brake mounts
- Remove drive axle nut (may need to get a new cotter pin if there is one already there)
- Unbolt the balljoints, 2 bolts located at the bottom that connect the control and steering arms to the wheel.
- Use a balljoint separator (basically a wedge) to pop loose the balljoint and arms.
- Pull the wheel out of the driveaxle, now the wheel can be angled so you can access the hub bolts.
- Break those loose, then remove the hub and rotor
- there are a couple of ways of separating the rotor and rotor: use two bolts (M8*1.25, I think) and screw into the two small holes located near the center, it should pop the hub loose. That didn't work for me, so I just sat the rotor between two bricks and used a soft mallet to bang out the center.
- Reverse the steps and that's it.
What else can I help you with?
How do you change the front wheel bearings on a Mitsubishi mirage?
The bearings must be pressed out of the hub and the new ones pressed in. Take it to a garage
How do you change the front wheel bearings on a 2001 Mitsubishi Mirage?
The bearings must be pressed out of the hub and the new ones pressed in. Take it to a garage
How do you tighten the transmission on a 1999 Mitsubishi galant?
on 1999 Mitsubishi galant the transmission have stop working it don't go front or back what can I do to fix it.
Can you drive a mitsubishi galant without the front ecu?
No, the car will not start.
Where is throttle position sensor on 1992 Mitsubishi Galant?
on the front side of the throttle body.
Size and shape of 2001 Mitsubishi galant speakers?
2001 Mitsubishi galant ES. Speaker specs Front door: 6 1/2" Rear deck: 6 x 9"
Where is the speed sensor for 2004 Mitsubishi Galant?
the speed sensor for 2004 Mitsubishi Galant is located on the front case of the transmission output shaft and speed sensor. It is approximately under the hood to the left of the engine.
Where is the oil pan located in a 2001 Mitsubishi Galant?
under the front of the car on the driver side .
Where is the Front Bank Sensor 1 on a 2001 4-cylinder Mitsubishi Galant?
in front of the cat sensor 2 is after the cat
What size center speaker is in 2002 Mitsubishi Galant?
The rear deck speakers in a 2002 Mitsubishi Galant measure 6 inches by 9 inches. The front door speakers measure 6 3/4 inches.
How do you change the front of GALANT 94 to GAlant 2001?
to change the front ends you need fenders bumper lights hood and a good idea of what your doing and that you have no need to change your 7th gen front end to an 8th gen
Where is the fuel filter located on a 1999 Mitsubishi Galant?
It's located in front of the back tire in the passenger side, it looks like a white short cylinder, and it is so easy to change it.
