You almost don't want to know... I just did it!!! It is quite involved. I took a bunch of photos of the process and I don't see that this site allows photos. But, here's the reader's digest version: 1. remove center console panel 2. remove lower console cover (held down by five screws) 3. remove wire harness that goes up to the OD button 4. unthread the wire harness up to the shifter lever 5. remove the two set screws that hold the shifting knob onto shaft. 6. Lift knob up and hold onto the shifting button when it springs out 7. Remove the little strip with the orange tab and then remove the gear indicator plate by pulling outward and upward along the edges 8 Put in new bulb 9. put it all back together again!!!!!!! It's NOT easy!!!
how to change light bulb light on the gear shift for a toyota matrix 2007
change bulbs in gear selector of 2001 oldsmobile aurora
To change the gear shift light in a 2006 Toyota Matrix, first disconnect the negative terminal of the battery for safety. Remove the gear shift knob by unscrewing or pulling it off, depending on the design. Then, carefully pry off the center console cover to access the light bulb socket. Replace the old bulb with a new one, reassemble the console and knob, and reconnect the battery.
How do you change the tail light on a 2001 toyota sequoia
GO TO A REPUTABLE MECHANIC >>>>DO NOT BE FOOLISH TRYING TO SAVE $$$$$
Low fuel you idiot
changing rear light bulbs on toyota avenis
top
The fuse for the shifter light on a Toyota Matrix is typically located in the fuse box under the dashboard on the driver's side. You can find the specific fuse for the shifter light by referring to the owner's manual, which provides a diagram and list of fuse assignments. If the shifter light is not functioning, check the fuse for any signs of damage or a blown filament.
how to change tail light bulb on Toyota sequoia
HOW TO FIX A PARKING LIGHT ON A 1996 TOYOTA COROLLA
To reset the maintenance required light on a 2010 Toyota Matrix, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. Then, turn the ignition off and back on again, and the light should be reset. If the light remains on, repeat the process to ensure it was done correctly.