if it is a 2001 model - there are normally 2 black buttons- one at either side the display.
Press and hold the button on the left hand-side until the hour on the clock starts flashing, then keep pressing the left hand button to your desired hour.
Press the right hand button until the minutes starts flashing and press the LHS button to your desired minute.
To finish either press the RHS button once again or leave until the minute flashing stops
To set the clock on a 2005 Nissan Almera SE, first, turn on the ignition without starting the engine. Locate the clock adjustment buttons on the dashboard; typically, there are buttons labeled "H" for hours and "M" for minutes. Press and hold the "H" button to set the hour and the "M" button to set the minutes. Once the desired time is displayed, simply release the buttons, and the clock will be set.
On the Dashboard Under Your Speedometer
i've tried to change the clock on my dashboard through the navi, it changes in the navi but not on the dash?? help!!
i dont drive but good luck
To change the bulb in the dashboard clock of a 2005 Pontiac Sunfire, first, disconnect the negative battery terminal for safety. Remove the dashboard trim surrounding the clock by gently prying it off with a trim tool. Then, unscrew the clock assembly and carefully pull it out to access the bulb. Replace the old bulb with a new one, reassemble the clock and trim, and reconnect the battery.
Go to command and select services time is there
Remove the top half of the dash board
See Page 4-17 of the owner's manual
To change the clock on a 2006 Jeep Commander Limited, first, turn on the ignition without starting the engine. Then, press the "Menu" button on the dashboard until you see the "Clock" option. Use the "+" and "-" buttons to adjust the hours and minutes, then save the settings by exiting the menu. Finally, ensure the correct time is displayed on the dashboard.
To change the clock in a GMC Yukon, first, turn on the vehicle and locate the clock display on the dashboard. Use the "Settings" or "Menu" button on the infotainment system or the dashboard controls to access the clock settings. Adjust the time using the buttons or touchscreen prompts, and make sure to save your changes before exiting the menu. If your model has a manual clock, you may need to turn the knob or press the appropriate buttons to set the time.
To set the clock on a 2002 Nissan Quest, turn on the ignition without starting the engine. Press the "Clock" button on the audio system or dashboard until the hour digits begin to blink. Use the "Seek" or "Tune" buttons to adjust the hour, then press the "Clock" button again to set the minutes, repeating the same adjustment process. Finally, press the "Clock" button one more time to save the settings.
No, there is not a reset button on the Nissan Xterra. However, there is a reset button on the clock in the Nissan Xterra to change the time. To reset the car, a technician would have to use their computer.