Ooh, this is a fun one. The water pump is driven by the timing belt, so you have to remove and replace that to change out the water pump.
~Pengauin
5.25" see Crutchfield.com
if you stop for gas
To change the shift solenoids in a 1993 Mitsubishi Diamante, first, disconnect the negative battery terminal for safety. Then, remove the transmission pan to access the solenoids, which are typically located inside the transmission assembly. Carefully disconnect the electrical connectors from the solenoids, remove the old solenoids, and install the new ones, ensuring a proper fit. Reassemble the transmission pan, refill the transmission fluid, and reconnect the battery.
yes it does r12. if you dont want to convert to the 134a. you can use freeze 12.
yes usaly in the same cicuit as the interior lights
if its sohc it doesnt have , if its dohc its behind the lower damper i think
no
On a 1993 Mitsubishi Diamante, the tension pull for the serpentine belt is typically located on the belt tensioner pulley. This tensioner is spring-loaded and automatically adjusts to maintain the correct tension on the belt. To release tension for belt replacement, you usually need to use a wrench to rotate the tensioner away from the belt. Always refer to the vehicle's manual for specific instructions and diagrams.
pretty sure it is the port on the right side of your engine (from view of the front ) about a foot away ( give or take a little)
Usually the lighter is shared with something else (like the horn). Check to see if there is something else not working and look for that fuse.
Diamante Music Group was created in 1993.
i have the same problem email your solution please cfinster11@yahoo.com