lock both doors, and then unlock only the passenger door with the key.
I have a '96 - try using the key in the door on the passenger side
To disable the factory alarm on a 1999 Acura CL 2.3, you can try unlocking the driver's side door with the key or using the remote if available. If the alarm is still activated, locate the fuse box and remove the fuse labeled for the alarm system. Additionally, disconnecting the car battery for a few minutes can also reset the alarm system. Be cautious, as this may affect other electronic systems in the vehicle.
I am a installer movil electronics yoghurt`s sound and to disable the factory alarm in 92 Acura vigor is to take-off the drivers door panel. It a 6 o 7 wires to run from the door key cylinder grab the wire green/black and grounded that`s it.
I am a installer movil electronics yoghurt`s sound and to disable the factory alarm in 92 acura vigor is to take-off the drivers door panel. It a 6 o 7 wires to run from the door key cylinder grab the wire green/black and grounded that`s it.
To disable the alarm on a 1991 Acura Legend, first, try unlocking the driver's side door with the key. If that doesn't work, you can disconnect the car battery for a few minutes to reset the alarm system. Additionally, locate the alarm control module under the dash or near the steering column and disconnect it if necessary. If problems persist, consult the owner's manual or a professional for further assistance.
To disable the security alarm for a 1989 Acura Legend, insert the key into the driver's side door lock and turn it to unlock. This action should deactivate the alarm. If that doesn't work, you can also try disconnecting the car battery for a few minutes to reset the system. Always consult the owner’s manual for specific instructions related to your vehicle's security system.
To disable the seat belt alarm on a Chevy Colorado, locate the alarm fuse. Pull out the fuse to disable the alarm.
that easy take out your alarm out your car i m sure your alarm will be disable
Honda factory alarm systems use a program function. To program the alarm turn the car into the on position and press the lock button. Do this three times in five seconds. Once in program mode and the alarm can be disabled.
You can disable the speed alarm by removing the speed alarm fuse. When the fuse is removed the alarm will not sound.
How do you disable the alarm system on a 1998 yukok