How do you disconnect seat belt alarm on 2008 corolla?

Answer 1

Here is your solution to the annoying seatbelt alarm (works on all

Toyotas, I used it on my 2005 Corolla and yes, I always use my

seatbelt):

(1) Turn the Car "ON," but do not start the engine (leave your foot

off the brake, don't fasten seatbelt). Cycle your trip reset knob

until it reads ODO. Turn the ignition back off. Wait a couple of

seconds.

(2) Make sure your seat belt is not fastened.

(3) Turn the ignition back on, do not start the car (leave your foot

off the break, don't fasten seat belt). As soon as you see

everything light up, press and hold the trip reset knob and do a long

12 second count.

(4) Keep your finger on the trip reset knob. Fasten your seat belt.

As soon as you fasten your seat belt, you should see the ODO display go

from XXXX miles to "b-on." At that time, take your finger off the

trip reset knob and it should cycle to "b-off." If it doesn't,

just press the knob again until "b-off" appears. Once "b-off"

appears, turn the ignition off and unfasten your seat belt. Now, when

you start your car, you should hear the "normal" seatbelt beeping,

then when you go over 10 mph, if your seatbelt is not fastened, it

won't beep 54 times... the seatbelt signal will just continue to

flash... but no more annoying beep!!