answersLogoWhite

0

It is located over your head in the panel that controls the garage, sun roof, etc. Use something flat such as a butter knife and pry on the side closest to the back of the car. Once that is down, there are 3 cables that you will disconnect. THEN you will need a 8mm socket to unscrew 4 bolts. (i used pliers) Once the 4 screws have been removed, the inner case will pop free. In that case is another cable. This is the cable that plugs directly into the HFL. Simply pull it out.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you clear the codes on a 2001 Acura TL?

Disconnect the battery for 5 min


How do you reset Acura TL hands free link?

To reset the HandsFreeLink system in an Acura TL, start by turning the ignition to the "On" position without starting the engine. Then, press and hold the "Talk" button on the steering wheel until you hear a voice prompt. Follow the instructions to reset the system, which typically involves confirming the reset action. Finally, you may need to reconnect your Bluetooth devices afterward.


Reset Acura RSX check engine light?

Disconnect the Battery for 5 minutes


Why does my a c now only blow hot since i installed a new alternator on my acura?

disconnect the ac compressor and reconnect it


Reset check engine light on 2000 Acura TL?

Disconnect the negative terminal to the battery for 3 min.. It worked for me :)


How do you change the headlamp bulbs on a 1996 Acura TL 2.5?

The headlamp bulbs on a 1996 Acura TL are installed from the engine bay. Find the housing located in the front of the vehicle. Disconnect the bulbs and replace them with new units.


How do you disconnect acura 3.0 CL car alarm?

The 3.0 Acura CL alarm system is wired into a car alarm brain. This will need to be disconnected. It is advised that a professional disconnects it as doing this incorrectly will leave the car unable to be used.


How do you replace rear corner brake light bulb in 98 Acura CL?

To replace the rear corner lights on a 1998 Acura CL open the trunk. Find the brake light housing and disconnect the bulb. Install the new bulb.


How do you replace the clock in an Acura RL 1996?

To replace the clock in a 1996 Acura RL, first, disconnect the negative battery terminal to ensure safety. Remove the dashboard trim panel surrounding the clock by gently prying it off. Unscrew the clock unit from its housing, disconnect the wiring harness, and replace it with the new clock. Finally, reassemble the dashboard trim and reconnect the battery.


How do you replace rack and pinion on a 2003 acura tl 2.3?

Lift the Acura. Drain the power steering fluid. Disconnect the steering joints from the power steering rack. Unbolt the race and remove. Install the new rack and connect the steering back up.


How do you change transmission solenoid on a 2002 acura?

To change the transmission solenoid on a 2002 Acura, first, disconnect the negative battery cable and drain the transmission fluid. Remove the transmission pan by unscrewing the bolts, then detach the filter to access the solenoid. Disconnect the electrical connector from the solenoid, unbolt it, and replace it with the new solenoid. Reassemble the components in reverse order, refill the transmission fluid, and reconnect the battery.


How do you change a Acura TL 2.5 starter?

To change the starter on an Acura TL 2.5, first disconnect the negative battery cable to ensure safety. Then, access the starter by removing any components obstructing it, such as the air intake or engine cover. Unbolt the starter from the engine block, disconnect the electrical connections, and replace it with the new starter. Finally, reassemble everything, reconnect the battery, and test the new starter.