answersLogoWhite

0

pretty much only way to stop the fuel, is if you have an electric fuel pump, you can remove fuel pump fuse.but you really dont need to do this for a compression test. in performing a compression test, you need to remove spark plugs to use compression gage. before you start, remove the lead that goes from distributor to coil, and you will not have spark at the plugs you can also use a remote stater switch connected to starter motor and leave ignition turned off. the engine will still turn but no ignition will be available to start engine

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What is the spark plug gap setting for a 1994 Honda Civic?

The spark plug gap for a 1994 Honda Civic should be set at .044 inches. This gap will be preset at the factory for new spark plugs.


How far is the spark plug gap on a 1994 Honda Civic?

0.43


What is the spark plug wiring order from the plugs to the distributor on a 1998 Honda Civic 1.5l?

What is the proper spark plug wire placement routing to the distributor for a 1994 Honda civic cx


If i replace slave cylinder will that make my clutch disengage and engage correctly?

if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.


Where is the spark plugs in a 1994 Mitsubishi pickup?

follow your plug wires from your distributor,just remember dont pull on the wires to disengage them,pull on the base[CLOSEST TO THE PLUG].


Why will my 1994 Toyota pickup will not start?

No spark, No compression, no fuel or timing off. Any or all of these could be an issue and then multipul reasons for each of them.


What is the compression in a 1994 Buick century 3.1?

What is the COMPRESSion for 1994 buick century


What would make a 1994 Trooper to lose power when it is going up a hill and spark knock?

If a 1994 Trooper loses power going up hill and has a spark knock in the engine, the compression of the engine should be checked. It is possible that the vehicle is not running on all of its cylinders.


Why would a 1994 S10 blazer 4.3 vortec will crank but will not start but the fuel pressure is good?

You need three things for the engine to run, compression, fuel and spark. You say you have fuel now check for spark.


1994 grand am misses or jerks under a load what could be the cause?

Not running on all cylinders: Bad spark plug? Bad spark plug wire? Bad valve? blown piston? Do a compression test


Where should the cam position be when setting timing marks on a 1994 Honda Civic 1.5L sohc?

#1 piston should be at TDC and both valves closed (compression stroke)


If a 1994 225 kawasaki bayou is not getting fire whats wrong with it?

make shure the spark plug is getting spark and u have enoguh compression in the enigine. im 14 years old and i kno alot about it for my age