You don't. The 2000 Elantra has hydraulic lash adjusters, not fixed-height shims. They adjust the valve lash automatically, constantly.
fuel vent valve is on the top of the gas tank
the egr valve is located at the back of the engine on the drivers side
1997-2000 Hyundai tiburon, 1997-2000 elantra.
Look on this page, it even has pictures: http://www.fixya.com/cars/t1002349-location_charcol_canister
find the location of a 2000 hyundia elantra starter
no, different designs.
Its should be same thing
The heater control valve on a 2000 Hyundai Elantra GLS is typically located in the engine compartment, near the firewall on the passenger side. It is connected to the heater core and the coolant hoses. To access it, you may need to remove some components for better visibility. Always refer to a repair manual for specific instructions and diagrams.
The spark plug gap for a 2000 Hyundai Elantra should be set at .044 inches. New spark plugs will be preset at the factory.
The starter on a 2000 Hyundai Elantra is located along the bottom, left side of the engine. It bolts directly to the engine block and is protected by a shroud.
attached to the rubber line that runs off the intake manifold. It should be near the brake booster.
no it won't the 2000 has diffrent plugs by the dip stick its a six pin . i made that mistake and got a 99 at trans for my 2000 and notice its the same in a accent 97-99 and the elantra but change in 2000 hope this helps