Fusible links are generally located close to the main power source such as the battery or accessory solenoid.
950.00
you have a black box behine the battery open it and look on the inside panel of it
Yes, a Mazda B2000 is most definitely a 4-cylinder with a 2.0L engine. However, technically Mazda didn't produce the B2000 as a 1988 model. It was made in 1986-1987. Then in 1989 Mazda made the B2200 Pickup, which is a 2.2L 4 cylinder.
it connects to any positive(hot wire) terminal controlled by key.
http://www.autozone.com/addVehicleId,1061802/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c1528005cb78
Unless you modify the intake manifold with some welding an adapter plate is required to install a Weber or Holley 5200 carb on a Mazda B2200 or B2000. The adapter plate for the Weber 32/36 will work to install the Holley 5200 as well. See the attached links for additional information.
how to remove lock cyliner switch 1988 Isuzu pickup
The 1988 Mazda B2200 pickup does not use OBD-II codes, as this standardized system was introduced in 1996. Instead, it likely employs an earlier diagnostic system, often referred to as OBD-I, which may not provide the same level of diagnostic information. To retrieve any trouble codes, you would typically need to use a specific diagnostic tool or follow a manufacturer-specific procedure.
The fusible links on a 1993 Ford Ranger are located throughout the vehicle and primarily in the engine compartment. They prevent circuit overloads and must be replaced each time they are burned through.
no 84 and 85 swap out.
complicated
Click the link.