Its the black handle at the bottom of the dash panel, just below the steering wheel.
To replace the broken handle you will first need to remove the broken piece using a screwdriver. Once the broken handle is removed place the new one in it's place and screw in.
To replace the liftgate handle on a Ford Freestar, start by opening the liftgate and removing any trim pieces or covers around the handle, typically secured with clips or screws. Disconnect the wiring harness if applicable, then unscrew the old handle from the liftgate. Install the new handle by reversing the removal process, ensuring it is securely fastened and reconnect the wiring if needed. Finally, reattach any trim pieces and test the handle for proper operation.
To replace the broken handle you will first need to remove the broken piece using a screwdriver. Once the broken handle is removed place the new one in it's place and screw in.
how to open liftgate on 98 lincoln navigator that is stuck
To repair a broken rear hatch handle on a Toyota Sequoia, start by removing the interior panel of the hatch door to access the handle mechanism. Inspect the handle for any broken parts or disconnections; if necessary, replace the handle with a new one. Reattach any loose cables or components and ensure they function properly before securing the interior panel back in place. Finally, test the handle to confirm it operates smoothly.
The interior panel pops off and there is one screw behind the little panel underneath the strap handle.
Lift the handle right above the license plate.
To open the rear hatch on a Chevrolet HHR, locate the liftgate handle near the bottom of the hatch. Press the handle or use the key fob to unlock and open the hatch. If the vehicle is equipped with a power liftgate, you can also press the liftgate button on the dashboard or key fob to activate it. Ensure the vehicle is in park for safety before opening.
if your lift gate is stuck on your Chevy were the back handle is the clips have broken so i would go and get new ones and there easy to put in take a flat head pop plastic off and then pull broken ones out and replace then and work like new not like a ford
If its the cables inside you need to remove the panels and replace the cables. You can in a pinch just disconnect them from the handle. Then pull them to release the door.
I would recommend J B Weld or Araldite for this.