0
What else can I help you with?
How do you install 1993 rodeo distributor?
install distributor rodeo 1993
Where is the distributor on a 1993 Corvette?
The distributor is on the front of the engine.
Does a 1993 Mitsubishi eclipse have an electronic ingtion module in the distributor?
Yes, the 1993 Mitsubishi Eclipse is equipped with an electronic ignition module located inside the distributor. This module controls the timing and firing of the spark plugs, essential for the engine to run smoothly.
Does 1993 colt 1.5 to install a distributor Does 1 need to TC on compression stroke?
Turn the engine until the #1 plug is at TDC on the compression stroke. Mark the distributor at that location. Install the new distributor and turn until you are at the exact same location. Have the timing checked after you get it started.
Where is the distributor on a 1993 aerostar 3.0 V6?
On a 1993 Ford Aerostar , 3.0L V6 engine : The distributor is located on the TOP of the engine , near the REAR
Is the 1993 eclipse 1.8 liter engine a non-interference engine?
The 1993 Mitsubishi Eclipse with the 1.8 liter engine is not on the list of cars with interference engines. The 1989-1998 2.0 Galant Eclipse cars were built with interference engines.
How do you install distributor in 93 Probe?
To install the distributor in a 1993 Ford Probe, first ensure the engine is in the correct position (usually at TDC on the firing stroke for cylinder 1). Remove any necessary components that obstruct access to the distributor. Align the distributor with the corresponding mark on the engine, then insert it while ensuring the rotor points to the correct cylinder. Finally, secure it in place, reconnect any wiring, and reassemble any components you removed.
What is the horsepower on a 1993 Mitsubishi eclipse with a 1.8L 4 cylinder engine?
The 1993 1.8L engine has 92 horsepower.
Where is the distributor on a 1993 E150 ford van located?
On a 1993 Ford E-150 GASOLINE engine : Follow the spark plug wires to the distributor cap on top of the distributor On the 4.9 liter / 300 cubic inch inline six cylinder engine ( the distributor is on the DRIVERS SIDE of the engine ) On the V8 engines it is ( near the front of the engine on the top of the engine )
Where is the pressure sending unit on 1993 dodge Dakota with 318?
Back of the engine, next to the distributor.Back of the engine, next to the distributor.
Where is the oil sending unit on a 1993 Dodge Dakota 3.9 engine?
It is on the back of the engine, next to the distributor.
How do you install b18 c into 1993 civic?
you can install it by putting it in the engine bay
