answersLogoWhite

0

The outside driver and passenger mirrors are held by two bolts that are accessible by removing the plastic cover at the base of the mirror. To remove the cover place a small putty knife between door and the cover and gently pry it off. After removing the cover, you'll see two 12mm bolts(do not remove yet). Next you'll need to remove the inside upper door panel. There are two Phillips screws holding the panel to the door. First screw is at the door latch/lock assembly. The second is locaterd behind a quarter sized plastic cover near the lower middle section of the panel. After removing the screws pry the lower section and then pull up(the lower section of this panel is attached with push clips). Before you can completely remove the panel. disconnect the red and white clips holding the lock and lever rods and the electrical. With the panel removed, peel back the clear pastic sheet near the hinge and there next to the wiring harness, you'll see a small white connector approx. 9 inches below the mirror bracket. Disconnect and now you can remove the two 12mm bolts holding the mirror to the door. Installation is reverse order.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How to install real view mirror on S70 Volvo?

Inside or outside?


Install a rear view mirror with compass on Toyota Highlander?

http://mojavetrail.webng.com/AutoDimMirror.pdf


How do you replace a passenger side door mirror that is electric on a 1991 Toyota Previa mini van?

remove the screw that holds the door handle inside get a pry bar and pry the top portion of the panel it will pop open look where the mirror goes you "ll see three screws that hold the mirror to the inside remove them unplug the wire that conects the mirror , install the new one and reverse the presigues,, ok??


How do you install a passenger side view mirror on a 1995 Toyota Tacoma?

on the inside of the door, opposite of the mirror there is a plastic cover, remove the cover and the bolts holding the mirror on will be exposed.


How do you install a side mirror on a caddilac dts?

To install a side mirror on a Cadillac DTS, first, remove the interior door panel by unscrewing and unclipping it. Disconnect the wiring harness for the mirror if it’s powered. Unscrew the old mirror from the outside and replace it with the new one, securing it with screws. Finally, reconnect the wiring, reattach the door panel, and test the mirror for proper functionality.


How do you install right side mirror on 1996 Mercedes Benz E320?

This is done from outside the vehicle. Fold the mirror back toward the door and you'll see the 3 mounting screws.


How do you install a passenger side power mirror on a Ford Fusion?

how to install driver mirror


How do you remove and replace the driver-side mirror in a 2001 Toyota Camry?

To remove and replace the driver-side mirror on a 2001 Toyota Camry, start by carefully prying off the plastic cover at the base of the mirror to expose the mounting screws. Use a socket wrench to remove the screws securing the mirror to the door. Disconnect the electrical connector if your mirror is powered, then pull the mirror off. To install the new mirror, reverse the process: connect the electrical plug, secure the mirror with screws, and replace the plastic cover.


How do you replace the driver's side mirror on the 2004 Toyota Sienna?

To replace the driver's side mirror on a 2004 Toyota Sienna, start by carefully removing the interior door panel to access the mirror's mounting screws. Disconnect the electrical connector if the mirror is powered, then unscrew the old mirror from its mounting bracket. Install the new mirror by reversing the process: secure it with screws, reconnect any electrical connections, and reattach the door panel. Finally, test the mirror's functionality before finishing up.


How do you replace mirror on Nissan Quest?

The outside mirror is held on by two retaining bolts and a wiring harness. Remove the inside door panel to view the mirror retaining bolts. After removing the retaining bolts and wiring harness reverse the process to install the new mirror.


How do you install replacement mirrors on a 1997 Geo Metro?

Open the door and remove the little black plastic cover in the corner.. just pry it off carefully.Remove the 3 screws in there while someone outside holds the mirror assembly.Reverse steps to install new mirror.


Can i put a mirror pointing outside in my home windows so neighbers lights don't bother me?

Shades are easier to install and more effective.