0
if you are trying to raise or lower the window by by-passing the switch you need to remove the door panel. Locate the wire connector to the window regulator motor. this will be 2 wires, red and green. disconnect the plug-in and use 2 jumper wires from the battery. touch the wires to the motor lead connectors and see which way the regulator moves. alternate the battery wires to achieve the results you want. hope this helps.
What else can I help you with?
Why won't the rear driver side window in 1998 Toyota Avalon work?
The rear side window in a 1998 Toyota Avalon can jam if there is a problem in the window motors or the switches. A faulty switch may not complete the circuit needed to operate the window.
1998 Toyota Avalon passenger window does not go back up using the electronic switch?
Several thins can cause the 98 Avalon window to not go up. The switch could be bad, the motor relay could be bad, or the motor itself can be defective.
How do you replace a master window switch on a 1996 Toyota Avalon XL?
Some of the switches just pry out of the door and you simply plug on another switch. Good luck
How do you replace Toyota Avalon washer pump?
How difficult is it to replace a 2000 Toyota Avalon window washer pump and where is it located?
How do you bypass electric window switch on Toyota pickup?
how do you bypass electric window switch on 88 toyota pickup
Where is the annetana on a 2001 Toyota Avalon?
in the window, no antenna to pull as in old cars
How do you bypass power window switch with a jumper wire to raise window?
To bypass a power window switch using a jumper wire, first, identify the switch terminals for the up and down functions of the window. Disconnect the switch from the wiring harness, and using a jumper wire, connect the terminal corresponding to the window motor's power feed to the terminal that activates the motor for raising the window. Ensure you're cautious to avoid short circuits, and only maintain the connection briefly to avoid damaging the motor. Always reconnect the switch afterward to restore normal function.
How can you get your drivers side window to go up when the switch is out?
Remove the door panel, find and unplug the window motor. Use jumper wires to supply battery voltage from the door lock switch (or use jumper cables and jumper wires to get power to it from the battery) to the two contacts on the motor. If the window goes the wrong way, switch the wires at the motor. Leave the window motor unplugged so it can't be rolled down accidentally until you are able to properly repair the window.
How do you jumper the window switch to get the window to come go up on a 1991 Ford Aerostar?
If you press the switch and hear the motor running, the the gear kit needs to be replaced. If you do not hear it, look at the dome light and see if it dims when you press the switch. If it does then you have a bad motor.
How do you bypass window switch on a 99 Pontiac Montana?
To bypass the window switch on a 1999 Pontiac Montana, you can use a jumper wire to connect the window motor directly to the power source. First, remove the door panel to access the window motor and locate the motor's power wires. Then, carefully connect the jumper wire to the appropriate terminals on the motor, allowing you to raise or lower the window manually. Exercise caution to avoid short circuits or damaging the motor.
Where is the passenger window relay located on a Toyota supra?
The windows use a switch which is in the door.
Which contacts on a 98 Dodge Durando SLT 5.2 driver power window switch or motor do you cross to move the window?
look for the wires that go to the driver window switch, there will be 3, two of them will make window go up, 2 will make window go down. use a small jumper wire to brige them
