0
How do you loosen and replace the belts on a 1994 Nissan pickup?
Wiki User
∙ 17y ago
tools...and ...everyone should have a manual for their vehicle, and the local library should have a professional shop manual available, to make copies of, in the Reference section...good luck:)
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you replace and thread the belts on a 1986 Nissan 4WD pickup?
Is it the 86 or 86.5?
How do you replace the belts on a 1995 Nissan 240sx?
loosen the manual tensioners and the alt bracket.
How do you replace an alternator on Nissan Frontier?
Loosen the belts, unbolt the old alternator, bolt the new one on, tighten the belts back up.
How many belts in a Nissan 95 pickup?
three belts
How do you replace alternator on 1986 Nissan 300 zx 3.0 liter 2 2?
Loosen the tension on the belts, unbolt the old one, bolt in the new one, and retighten the belts.
How many belts are in the engine of 1997 Nissan pickup?
3
Does a 92 Nissan pickup have a timing belt or a chain?
Yes 4 cylinder have chain and 6 have belts.
How do you replace an air conditioning compressor in your 1993 Nissan Pickup Truck?
you need to drain all the freeon out of the system. take the belts off. and take the bolts on the compressor out. its best to get under the truck. and there is a lot of wiggling to get out.
How do you replace alternator in infinity Q45 1999?
there should be two major bolts to the alternator one to losse'n up the belts and the other to release the alternator to the mount. loosen the belts first and then remove the belts.. after this it should be easy to replace the alternator
How to change serpentine belt in a 2002 Nissan Pathfinder?
From the front remove the brush cover on the bottom of the truck. You will find the two tensioners for the two belts. You will have to loosen the center nut(i think it is a 14mm). once loosened there is a 12mm bolt, loosen that and the tensioner will open. remove the belts and replace with new ones. Be sure to write down the routing, draw a sketch, or a take a picture. Reverse order to tighten.
Where is water pump located on 97 Nissan Sentra and how to replace it?
The water pump on a 97 Nissan Sentra is behind the timing belt. To replace it you will need to drain the coolant, remove the cylinder head, loosen pulley bolts, drive belts, and water pump pulley. Next, remove coolant hoses, water pump bolts, and finally the old water pump. Reverse directions to replace with new pump.
How do you replace a compressor belt on a 4 cylinder engine for a 1993 Nissan altima GXE?
jack up the passenger side of the car. remove the splash guard in side the wheel well (all the black plastic inside fender)and remove the tire then u can acsess the belts. there are 3 sperate belts with non automatic idler pullys. loosen the idler pullys of the belts until u get to the compresser belt. replace then reinstall and tighten the belts with the idler pullys to repair manuel specs. a special tool will be required to get the correct tension of the belts
